EGMSUVSA95-05
Installation Instructions Manual
EGMSUVSA95-05
Installation Instructions Manual
IMPORTANT
If you run into any issues with the installation of this item
please call our Tech Support line at 844-336-7625 (844-3-Enrock)
Look over the instructions one last time before you call to make sure
the installation was performed exactly as the instructions stated.
Please have the vehicle nearby and ready
to perform troubleshooting steps before calling.
USE THE FOLLOWING INSTRUCTIONS FOR EACH FRONT DOOR LOCATION
Disconnect the negative battery terminal to prevent an accidental short circuit.
Using a window crank removal tool, release the spring clip securing the window
crank handle and remove. Remove (2) Phillips screws from the armrest. Unclip the
triangular trim piece in the upper corner of the door panel. Pop out the cover cap
rom the upper-inside corner of the door panel and remove (1) screw exposed.
Using a small screwdriver, unclip the door latch trim and remove. Unclip the
perimeter of the door panel and remove the panel. (NOTE: The plastic
along the seam of the panel is very thin, use extreme care when removing).
Unclip the factory speaker (if present) and disconnect the wiring.
FEATURES:
Adapts 5¼" or 6½" speakers to front door locations
COMPONENTS:
(2) Speaker Adaptor Plates
TOOLS NEEDED:
(2) Speaker Adaptor Plates
Prepare for installation
Window crank
removal tool
Cutting toolPhillips screwdriver
1
(PASSENGER SIDE
APPLICATION
SHOWN IN
ILLUSTRATION)
EGMSUVSA95-05
EGMSUVSA95-05
ALL MODELS (EXCEPT SIERRA 1999, SILVERADO 1999):
To mount the assembly with clips, cut and remove mounting clips "A" and mounting
tabs "C" from the Speaker Adaptor Plates. To mount the assembly with screws
(heavier speakers), cut and remove mounting clips "A" only. (see Fig. A).
SIERRA 1999, SILVERADO 1999: Cut and remove mounting clips "B" from the Speaker
Adaptor Plates. (see Fig. B)
2
Fig. B
"A"
"A"
"C"
Fig. A
"B"
4
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
3
Mount the aftermarket speaker to the
Speaker Adaptor Plate with the screws
supplied with speaker.
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
5
(PASSENGER SIDE
APPLICATION SHOWN IN
ILLUSTRATION)
Fig. A
Fig. B
(PASSENGER SIDE
APPLICATION SHOWN IN
ILLUSTRATION)
re-connect the battery terminal and test the speaker for proper operation. Mount the
assembly to the door frame with (3) clips.
/
