EBUDK00
Universal Fully Enclosed Under Dash Installation Kit
EBUDK00
Universal Fully Enclosed Under Dash Installation Kit
IMPORTANT
If you run into any issues with the installation of this item
please call our Tech Support line at 844-336-7625 (844-3-Enrock)
Look over the instructions one last time before you call to make sure
the installation was performed exactly as the instructions stated.
Please have the vehicle nearby and ready
to perform troubleshooting steps before calling.
Features:
DIN Head Unit Provision
Various Mounting Depths
All Vehicles:
If additional depth is preferred, cut the Under-dash Housing along the scored line to
remove the back-end section of the Housing (See figure)
(Continue to Installation)
Contents:
Under-dash Housing
Eight (8) Phillips Screws
Tools Required:
Phillips Screwdriver,
Adjustable Wrench
Cutting Tool
EBUDK00
1 2
Warning:
Enrock recommends disconnecting the negative battery terminal prior
to the installation process. All switches, accessories, and especially air
bag indicator lights MUST BE plugged in before reconnecting the
battery and cycling the ignition. Refer to your aftermarket radio
instructions.
Prepare for Installation
DIN Head Unit Provision:
1. Slide the DIN cage into the kit and fasten by flexing the metal secure tabs
downward.
2. Slide the aftermarket head unit into the DIN cage until it’s securely in place.
(See figure 1)
EBUDK00
3 4
InstallationInstallation
3. In the dash, locate the factory wiring harness and place the unit and into the
preferred mounting location. (See figure 2)
4. Guide the head unit/kit assembly underneath the dash until the preferred
mounting location.
5. Mark the screw holes into the dash.
6. Reconnect the negative battery terminal and try out the unit to ensure proper
operation.
7. With the eight (8) supplied Phillips screws, mount the unit to the pre-marked
holes on the dash. Note: fewer screws will be required if the back of the
Under-dash Housing was removed in Step 1) (See figure 3)
figure 1
figure 2
figure 3
/
