LBL Lighting PW559BOPSICF1HE Installation guide

Type
Installation guide

This manual is also suitable for

1C
1B
Installation Instructions for
Small Omni (Compact Fluorescent)
980OMNISWCF
Feed the fixture wires through the mounting plate side hole.
Connect the ground wire to a suitable ground in accordance
with local electrical codes.
Connect the white wire to the neutral power line wire.
Connect the black wire to the hot power line wire.
1
MOUNTING PLATE
1A
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product can be dimmed with a standard incandescent dimmer.
Mount the crossbar assembly to the electrical box holes with
the two #8-32 screws provided.
CROSSBAR
ASSEMBLY
ELECTRICAL BOX HOLE
#8-32 SCREW
2
Assemble the crossbar by screwing the crossbar nipple to the
cross bar and secure it by tightening the nut.
CROSSBAR
ASSEMBLY
CROSSBAR
NIPPLE
NUT
1.2
PW559
1
2
3
4
5
6
5
6
4
2
2
Install the Fixture
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Wall
1E1D
2
Line up the anchor with the center of the mounting plate hole
and push the anchor into the wall up to the threads.
Screw the anchor the rest of the way in with a screwdriver.
Secure the mounting plate to the anchor with the screw and
washer provided.
ANCHOR
SCREW
WASHER
Place all wires and wire nut connections properly inside the
electrical box.
Slide the mounting plate onto the threaded nipple. Secure the
mounting plate by tightening the cap to the nipple.
LOCK
WASHER
THREADED
NIPPLE
NUT
7
8
9
10
11
2B2A
2
SHADE
SUPPORT ARM
SUPPORT ARM
ALLEN WRENCH
Use the Allen wrench to remove the upper shade support arm.
Place the shade into the slot in the lower shade support arm.
Line up the slot in the upper shade support arm with the top
of the shade.
Use the Allen wrench to attach the shade support arm to the
top of the fixture.
Install the Lamp and Shade
LAMP
SOCKET
3
NOTE: When replacing the lamp, push down on the tab
in the middle of the socket to release the lamp.
3
4
1
2
5
Push the lamp base into the socket.
5
4
3
Use 18 Watt GX24Q-2 BaseMAX
Triple Tube Compact Fluorescent Lamp.
4
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

LBL Lighting PW559BOPSICF1HE Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI