Installation Instructions for
980SPHEREW
Install the Fixture
1.1
929_WS LED
Wall
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing
NEC compliant junction boxes.
This product is suitable for damp locations.
This product may be dimmed using a low-voltage electronic dimmer
or standard incandescent dimmer.
This instruction shows a typical installation.
Sphere Wall ( )LED
1A
Remove the two fixture screws on the sides of the
fixture using the provided Allen wrench.
Remove the mounting plate from the fixture base.
1
SCREW
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
3
ALLEN
WRENCH
MOUNTING
PLATE
2
1B
MOUNTING
PLATE
3
SCREW
3
11