ELK OUTDOORS EO-ROCCW2-ABY User manual

Care & Maintenance

While Highwood products are designed to provide years

of trouble-free, ultra low-maintenance service, the tips

below will help you keep them looking like new.

Because our products are made with a unique, non-porous all-weather material and

assembled with stainless hardware, you can feel confident leaving them outside year after

year. All outdoor products are however, exposed to airborne contaminants that build up

leaving a layer of dirt and grime.

CLEANING

Using hot soapy water and a stiff bristle brush will remove surface dirt and grime. Stubborn

stains can be removed with a water-based cleaner (E.g. Windex, 409, Pledge, Murphy’s Oil

Soap, Simple Green, etc.). You can also use a power washer with a medium/wide nozzle

setting to clean the surface of the product. Never use cleaners containing aromatic solvents

on Highwood material.

If your product is white and you see that dirt and surface contaminants are causing a dirty/

brownish tint, an extra step can be taken. Use a 75% bleach and 25% water mixture and

wipe the surfaces down. Allow the mixture to remain on the product for an hour, then rinse

thoroughly. (Be sure to do this in a safe location and protect your eyes, skin, and wear old

clothes).

MAINTENANCE

Your Highwood product is made from a next-generation outdoor material. If the material is

damaged during use (scratched or chipped), it can often be repaired.

Scratches — Take a very fine grade of steel wool (0000 grade) and “sand” the scratched area

in the same direction that the embossing pattern runs. Apply enough pressure to gradually

minimize the scratched area. Once the scratches are reduced, the surface area may appear

dull and possibly even lighter in color; however, this will be less noticeable over time and

with outdoor exposure. To finish the repair, apply furniture polish or carnauba wax and buff

to a finish.