5.Looselyinstallthe4hex-headbolts(M12x110mm)
andthe4locknuts(M12)fromthekitontotheplates,
andinsertthecrumberbarbetweentheplatesandthe
boltsasshowninFigure2.
Note:Torquetheboltsandlocknutsto124to154
N-m(91to113ft-lb).
Figure2
1.Locknut—M12(4)
3.Mountingplates
2.Crumberbar
6.Ifyouloosenedthe4boltsandthe4locknutsthat
securethecrumbermountingbracketstothemachine,
torquethemto217to271N-m(160to200ft-lb).
7.Installthecrumberbladeontothecrumberbarwith2
carriagebolts(1/2x4inch),aplate,2washers(1/2
inch),and2locknuts(1/2inch)asshowninFigure3.
Note:Torquetheboltsandlocknutsto91to113
N-m(67to83ft-lb).
Note:Thiskitincludes2optionsforcrumberblades,
6inchesand8inches.Onlyinstallonebladeatatime.
Figure3
Theboomandchainarenotshown.
1.Locknuts(1/2inch)4.Crumberbar
2.Washer(1/2inch)5.Carriagebolts(1/2x4
inch)
3.Spacer6.Crumberblade
2