Laser SPK-BT206 User manual

Type
User manual
SPK-BT206 Bluetooth Cordless Speaker
User Manual
SPK-BT206 USER MANUAL
1
IMPORTANT SAFETY INSTRCUTIONS AND PRECATIONS
IMPORTANT SAFETY INSTRUCTIONS AND PRECAUTIONS
Read instruction carefully before using this product.
Check the contents to ensure that the product and all accessories are included.
Observe all warnings and cautions when using this product.
Retain all manuals and documentation for future referral.
Retain all receipts/invoices for any warranty claims.
Only use this product in a manner described in this manual.
Do not use this device in extremely hot, cold, humid, dusty or sandy environments.
Do not use this device in electrical storms or other conditions if the likely hood of
lightning is possible.
Do not attempt to clean this product using liquid cleaners or aerosol cleaners. Use
only a damp soft cloth to clean the surface of this device.
Extreme Care should be taken when using this product near any body of water such
swimming pools, kitchen sinks, baths and alike.
This device is not waterproof. Do not use this device in the open if there is a high
level of moisture in the air.
Only place the device on a stable surface and ensure that any cables attached to the
device can not cause the device to fall.
There are no serviceable parts in this device. Attempts to open this device by
unauthorised personnel may cause further dame and void the warranty.
Images of product and accessories are indicative only and may vary slightly from
actual product.
We reserve the right to make changes to this document and the product without
notification.
SPK-BT206 USER MANUAL
2
TABLE OF CONTENTS
Table of Contents
IMPORTANT SAFETY INSTRUCTIONS AND PRECAUTIONS ......................................................... 1
CONTROLS AND INPUTS ............................................................................................................. 3
WHAT’S IN THE BOX ................................................................................................................... 3
INTRODUCTION .......................................................................................................................... 3
Introduction ........................................................................................................................... 3
Features ................................................................................................................................. 4
GETTING STARTED ..................................................................................................................... 4
Charging the Speaker ............................................................................................................. 4
CONNECTING THE SPEAKER ....................................................................................................... 5
Connecting the Speaker ......................................................................................................... 5
Pairing the Speaker ............................................................................................................ 5
Reconnecting ..................................................................................................................... 5
Audio Playback ....................................................................................................................... 5
Speaker Controls .................................................................................................................... 5
Pause/Play .......................................................................................................................... 5
Volume Control .................................................................................................................. 5
Turning the Speaker off ..................................................................................................... 6
Connecting a Second Speaker .................................................................................................... 6
Connecting left and right speakers ........................................................................................ 6
Pairing and audio device to the matched speakers ............................................................... 6
Speaker Controls .................................................................................................................... 7
Pause/Play .......................................................................................................................... 7
Volume Control .................................................................................................................. 7
CONNECTING THE 3.5MM AUX CABLE. ..................................................................................... 7
TROUBLE SHOOTING .................................................................................................................. 8
TECHNICAL SPECIFICATIONS ...................................................................................................... 9
FOR OTHER ACCESSORIES AND PRODUCTS ............................................................................... 9
CONTACT INFORMATION ........................................................................................................... 9
WARRANTY AGAINST DEFECTS ................................................................................................ 10
SPK-BT206 USER MANUAL
3
CONTOLS AND INPUTS
CONTROLS AND INPUTS
Item
Description Item
Description
1 Pairing key 6 DC input (micro USB)
2 Volume Down button 7 Charging LED
3 Mode button 8 Power on/off switch
4 Pause/Play button 9 Audio in (3.5mm stereo)
5 Volume up Button
WHAT’S IN THE BOX
1) SPK-BT206 x 1
2) Micro USB power cable
3) 3.5mm to 3.5mm AUX Input cable
4) User Manual (this Document)
INTRODUCTION
Introduction
Thank you for purchasing the SKP-BT206 wireless speaker with duo option. This speaker can
be used as a mono speaker paired to any device with a Bluethooth audio feature, such as
mobile and smart phones as well as Bluetooth enabled tablets. It can also be paired with a
second SPK-BT206 speaker (sold separately) for true wireless stereo sound.
SPK-BT206 USER MANUAL
4
FEATURES
Features
Easy pairing to devices.
Easy charge by any (powered) USB port.
Can be placed up to 10 meters from device.*
Long Play time between charges.
Portable
3.5mm aux audio input
Connect another for High quality stereo sound
Play/Pause and volume control on speaker.
Soft touch controls.
Bass reflex chamber for rich, deep tones.
*Distance dependant on line of site and interference from other devices/sources.
GETTING STARTED
Check the contents of the box and make yourself familiar with the controls and inputs of the
SPK-BT206
Charging the Speaker
While the SPK-BT206 may have some charge, we recommend that when charging the SKP-
BT206 for the first time it is left to charge overnight. Subsequent charging will take far less
time to complete.
Using the included micro USB cable, connect the small end to the DC-Input on the rear of
the speaker and connect the other to a powered USB port on a PC, Laptop or AC to USB
charger.
When charging the Charging LED on the rear of the speaker will light red. When the speaker
is fully charged the LED will go out.
SPK-BT206 USER MANUAL
5
GETTING STARTED
CONNECTING THE SPEAKER
Connecting the Speaker
Pairing the Speaker
1) Press and hold the power button on the rear of the speaker for 3 to 4 seconds until a
tone is heard from the speaker. This indicates the speaker is now turned on.
2) Press and hold the Pairing key for 2 seconds until a short tone is heard and the
pairing key starts flashing rapidly blue.
3) Turn on a compatible device and connect to the SPK-BT260 through the devices
Bluetooth menu as described in the devices user manual.
Reconnecting
Once the speaker has been paired to a device, it is paired to that device until it is paired to
another.
To reconnect to a paired device, ensure the Bluetooth feature on the device is on and turn
the speaker on. The device should automatically connect to the speaker.
Audio Playback
1) Select an audio track to play as normal on your device and press play on the devices
app or software.
2) Volume and playback can be controlled on the device as per normal.
Speaker Controls
Pause/Play
Playback can be paused by tapping the Play/Pause button on the front of the speaker. Press
again to resume playback.
Volume Control
Volume can be adjusted be tapping the Volume Up Button (+) or Volume Down Button (-) on
the front of the speaker. The speaker will speak the phrase “Volume down” when the
Volume Down Button (-) is pressed speak the phrase “Volume up” when the Volume UP
Button (+) is pressed. The phrase “Maximum” will be spoken when the volume is up as far as
it will go.
SPK-BT206 USER MANUAL
6
TURNING THE SPEAKER OFF
Turning the Speaker off
To turn the speaker off, press and hold the Power button on the rear of the speaker for 3 to
5 seconds until the Pairing key turns red. Release the power button and the speaker is now
off.
Connecting a Second Speaker
Connecting left and right speakers
A second SPK-BT206 (sold separately) can be added to provide stereo sound.
1) Makes sure that both speakers are turned off.
2) Select a speaker and press and hold the power button on the rear of the speaker
until the pairing key starts flashing green. The speaker will also start beeping. This is
normal.
3) Select the second speaker and press and hold the power button on the rear of the
speaker until the pairing key starts flashing green. The speaker will also start
beeping. This is normal.
4) The pairing keys on both speakers will continue to flash green for about 30 seconds
until paired to each other. The Pairing key on both speakers will flash blue when they
are connected.
Pairing and audio device to the matched speakers
1) Tap the “M” button on the front of the speaker. Each speaker will state either “Left
Channel” or “Right Channel”. When used as a single speaker tapping the “M” button
will return the phrase “Standalone Mode”.
2) Pairing an audio device can only be done using the left speaker. Press and hold the
Pairing key for 2 seconds until a short tone is heard and the pairing key starts
flashing rapidly blue.
3) Turn on a compatible device and connect to the SPK-BT260 through the devices
Bluetooth menu as described in the devices user manual.
SPK-BT206 USER MANUAL
7
SPEAKER CONTROLS
Speaker Controls
Pause/Play
When 2 speakers are used, playback can be paused by tapping the Play/Pause button on the
front of either speaker. Press again to resume playback.
Volume Control
Volume can be adjusted be tapping the Volume Up Button (+) or Volume Down Button (-) on
the front of either speaker. The speaker will speak the phrase “Volume down” when the
Volume Down Button (-) is pressed speak the phrase “Volume up” when the Volume UP
Button (+) is pressed. The phrase “Maximum” will be spoken when the volume is up as far as
it will go.
Volume can be adjusted on each of the speakers to set the correct level and balance to
accommodate where the speakers are located. The volume control on the connected device
can then be used as the master volume.
CONNECTING THE 3.5MM AUX CABLE.
Devices can be connected to a single speaker only using the supplied 3.5mm to 3.5mm aux
input cable.
Before connecting the cable to speaker, please ensure that the volume on the connected
device is lowered to about half before playback.
Connecting the Aux input cable to speakers that connected will disconnect the other
speaker.
The volume controls on the speaker can be used although no audible response will be given.
The “M” button and the play/pause buttons are disabled when the Aux input cable is used.
SPK-BT206 USER MANUAL
8
TROUBLE SHOOTING
TROUBLE SHOOTING
Problem Solution
Speaker will not turn on
Charge the speaker for approximately 2 hours.
Speaker will not pair to my
phone/tablet
Please refer to the user manual for your phone/table in
regards to pairing to a Bluetooth device.
Playback volume is low
Check the volume on the speaker(s)
Check the volume on the device.
Check the volume level on the media being played.
Volume is distorted
Adjust the volume on the Speaker(s) and the device and
lower until distortion disappears.
Cannot connect to second
speaker
Make sure that each speaker is charged before trying to
connect. Turn off and follow the connection steps
again.
Speaker is not charging
Make sure that the USB port that the cable is connected
to is powered.
SPK-BT206 USER MANUAL
9
TECHNICAL SPECIFICATIONS
TECHNICAL SPECIFICATIONS
Dimensions 130mm(H) x 110mm(W) x 110mm(D)
Weight 563 grams
Material PC + ABS
Power rating 8w
Speaker Impedance 4 ohm
Effective Frequency Range 86 – 21 KHz
Connections
Micro USB (Charging Only)
Standard Auxiliary 3.5mm input
Number of speaker 1 or 2 max
Battery 1200mAH Lithium-ion battery
Power Battery or DC input
Playback Duration Approx 20 hours
Bluetooth 2.1 + EDR (2.4G)
Controls Soft touch panel
FOR OTHER ACCESSORIES AND PRODUCTS
http://www.laserco.net/products
http://www.laserco.net
CONTACT INFORMATION
For more information on this product and technical support please visit
HTTP://WWW.LASERCO.NET
SPK-BT206 USER MANUAL
10
TECHNICAL SPECIFICATIONS
WARRANTY AGAINST DEFECTS
Laser Corporation Pty Ltd (“Laser”) warrants your new product to be free from defects in
materials and workmanship for 12 months, from the date of purchase, provided that the
product is used in accordance with accompanying recommendations or instructions where
provided. The benefit of this warranty is in addition to your rights under the Australian
Consumer Law and to other rights and remedies of the consumer under a law in relation to
the goods or services to which the warranty relates.
Through a network of retailers and resellers, Laser will provide you with your choice of a
refund, repair or exchange (where possible) for this product if it becomes defective within
the warranty period. This warranty will no longer apply where the defect is a result of
alteration, accident, misuse, abuse, normal wear and tear, neglect or improper storage.
Please retain your receipt as proof of purchase.
How to make a product warranty claim:
Step 1: Find your receipt which proves the date of purchase. Where the date of purchase
cannot be verified, your place of purchase or Laser will make an assessment based on the
date of manufacture, the condition of the Laser product and the type of defect.
Step 2a): Contact your place of purchase. They will assess the nature of the fault and refund
or replace the product as per their store refund or warranty policy.
Step 2b): If your place of purchase cannot be contacted, then you can contact Laser
Customer Service with details of your defective Laser Product Phone (02) 9870 3355; or
Email: [email protected] or online www.laserco.net/support/warranty (click on
“Consumers (End Users)”). Our business address is at 1/6-8 Byfield Street, North Ryde, NSW
2113
Step 3: Laser will issue you with a Return Authorisation (RA) number within 48 hours. When
requested, send us the defective product and a copy of your receipt. Laser will cover the cost
of the return delivery.
Step 4: Wait for us to contact you. Once we have received your defective Laser product for
inspection, we will inform you of our assessment of your claim within 7 days. When we
contact you, we will firstly let you know whether you have a valid claim under this Warranty,
and if so, we will inform you whether your defective Laser product will be replaced or
repaired, together with the number of days you can expect to wait to receive your replaced
or repaired Laser product.
Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and compensation for
any other reasonably foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the failure does not
amount to a major failure.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11

Laser SPK-BT206 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI