Hyper-Shock

HR903 Water-Resistant Bluetooth Speaker

High sensitive driver unit x 2

Push to open retractable

handle

POWER – with built-in LED

USB OUT - charge your mobile

devices

Push to open handle, to stand

vertically

Charging HR903 (14.8V rechargeable battery built-in)

1- Connect HR903 to AC adaptor (included), plug AC adaptor to wall socket.

2- Red LED turns ON during charging, turns OFF after fully charged.

3- Unplug AC adaptor after fully charged.

2- HR903 is in standby mode after power-on, blue & red LED blinks quickly.

3- HR903 will turn off itself to save power if left idle for 10 minutes.

4- Press any button located on top to activate HR903 from standby mode.

5- To manually turn off HR903 Bluetooth Speaker, press the POWER button.

Pairing HR903 with mobile devices (Bluetooth enabled) and Tablets.

1- Keep the speaker and mobile / tablet within a range of 3 feet when pairing.

2- Press and hold POWER button to turn on HR903, blue & red LED blinks quickly, speaker is in standby

3- Turn on the Bluetooth function of mobile / tablet and search through the Bluetooth devices. Select HR903

2: After successful pairing, paired devices will remain paired unless pairing information is deleted (no need to

pair when used next time).

3: HR903 goes to “searching” status with LED blinks in blue & red quickly if paired device is out of 33 feet range,

they return to paired automatically after the device is within the 33 feet range.

4: If you want to pair HR903 with a different device, first disconnect with existing device by either pressing the

BLUETOOTH button located on top of HR903 or switching off Bluetooth connection of existing device, and then

pair with the new device and follow 1-5 above.

Pairing HR903 with iPhone or iPad

1- Please keep HR903 and iPhone / iPad within a range of 3 feet when pairing.

2- Turn on HR903, blue & red LED blinks quickly, the unit is in standby for pairing.

3- Run the Bluetooth program of your system.

4- Please use “Search new device” function in the program.

5- Your system should find HR903 on your dialog, then double click the icon to confirm the program should

Pairing HR903 with Mac OS X 10 or above

1- Please keep HR903 and Mac within a range of 3 feet when pairing.

2- Turn on HR903, blue & red LED blinks quickly, the unit is in standby for pairing.

3- Pair it with Mac – choose setup Bluetooth Device from the Bluetooth status menu in the menu bar, and

4- Open System Preferences and click Sound.

3- Lightly swipe your phone on the NFC logo on top of device, while making minimal contact. The indicator

4- "Compatibility: Most smartphones with NFC running Android 4.1 "Jellybean" and later.

Re-connecting to a paired device

Each time HR903 is turned on, it has 2 options:

1- Connect to last connected devices automatically, then just start music playback.

2- Listed in the screen of devices as an output channel, then select HR903 Bluetooth Speaker as output

4- Press PREVIOUS to go back to previous song.

When there is an incoming call while HR903 is playing music via Bluetooth

1- Press PLAY/PAUSE/HAND-FREE to answer the phone call.

2- Press again to end the call.

Power-Bank: Use the “USB OUT” port to charge your mobile devices via HR903’s built-in battery.

1- Turn on HR-903

2- Connect HR903 with mobile devices via cable

3- LED blinks slowly in Green color when charging, turns off after mobile devices are fully charged.

1- AUX port can connect to any music devices via the AUX cable (included).

2- LED changes to Yellow color after AUX port plugged.

3- Play music through the device connected.

4- HR903 will turn off itself to save power if left idle for 10 minutes.