George Kovacs P1650-077-L User manual

Brand: George Kovacs

Model: P1650-077-L

Type: User manual

George Kovacs P1650-077-L is a versatile lighting fixture designed to enhance your indoor spaces with its adjustable features and elegant design. This wall-mounted fixture offers the convenience of dimming capabilities when paired with ELV dimmer switches, allowing you to create the perfect ambiance for any occasion. Its durable construction and easy installation make it a suitable choice for both residential and commercial settings.

P[-0\

Page 1/1

IMPORTANT: Fixture should be installed by a qualified

electrician to ensure proper wiring and installation.

Dimmable with ELV dimmer switches.

INSTALLATION INSTRUCTIONS FOR P1650-077-L

For Wall Mount Fixture

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVE RT I SS E ME N T ! CO U P E R L E C O U RA NT A U N I V E AU D E S FU S I B L E S O U D O D I SJ O N C TE U R.

AV E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F US I B L E S OU D O D IS J O N C T EU R .

PREPARATION

1. Shut off power at the fuse box or circuit breaker box. If

necessary remove the old fixture and mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts

on a clear area. Take care not to lose any small parts

necessary for installation.

MOUNTING THE FIXTURE (FIG. 1)

3. Secure the shade (A) with allen screw (B) using allen

screw wrench (C).

4. Secure mounting plate (E) to junction box (I) using junction

boxes screws (G) (Size: 8-32*1/2”L). The side of the

mounting plate marked “GND” must face out.

CONNECTING THE WIRES (FIG. 2)

5. At this point, connect the electrical wires as shown in Fig. 2,

making sure that all wire connectors are secured. If your

outlet has a ground wire (green or bare copper), connect

the fixtures ground wire to it. Otherwise, connect the fixture

ground wire directly to the mounting plate (E) using the

green screw provided. After wires are connected, tuck

them carefully inside the junction box.

FINISHING THE INSTALLATION (FIG.1)

6. Fix the canopy (D) to the mounting plate (E) by using

screws (H).

Your installation is now completed. Return power to the junction box

and test the fixture.

CAUTION /ATTENTION: When handling the fixture, do not

apply pressure to the LEDs. Hold the fixture by the base or

bracket.

Replacing LED module (Fig. 3)

The LED module can be replaced by a qualified electrician

without cutting of wire and without damage to any decorative

element to which the fixture is attached. See installation steps

for more details (Fig 3.)

a. Shut off power. Loosen screw (H) to disconnect the canopy

(D) from the mounting plate (E).

b. Loosen the wire (P)

c. Use the allen screw wrench (C) to loosen allen screw (B)

and take off the acrylic shade (A)

d. Remove the acrylic diffuser (J).

e. Loosen screws (K) to disconnect LED module (O), and

slightly pull out the LED module with the wire.

f. Reverse steps a-e for installing the new LED module.

FIG.1

Set # A-020-105

- Mounting plate - Ground screw

- Mounting screw*2pcs

Fig.3

George Kovacs P1650-077-L User manual

Brand: George Kovacs

Model: P1650-077-L

Type: User manual

Download PDF

report

George Kovacs P1650-077-L User manual

George Kovacs P1650-077-L User manual

Related papers

Other documents