Ultrak T-1 Operating instructions

Type
Operating instructions
Single countdown timer
Large display with big digits
Loud alarm when time is up
Built in memory
100 minute countdown capacity
Magnetic back clip and easel stand
ULTRAK T
1
TO SET TIMER:
Press "MIN", "SEC" buttons to set desired timing period.
Pressing the "MIN" or "SEC" buttons for approximately 3 seconds will advance the numeral at a faster rate.
TO START TIMER:
Once desired timing period is shown on display, press "START/STOP" button to start timer counting down.
Timer will continue counting down until it reaches zero, then the buzzer will sound for 30 seconds or until the
"START/STOP" button is pressed.
TO DISCONTINUE OR RESET TIMER FUNCTION BEFORE THE TIMING PERIOD ENDS:
To stop the timer before the timing period ends, press the "START/STOP" button. The time shown can be cleared
by using the "CLEAR" mode (pressing the "MIN" and "SEC" buttons together).
The timer can be temporarily stopped by pressing the "START/STOP" button. To restart, press the "START/STOP"
button again.
BUILT-IN MEMORY FUNCTION:
The same countdown timing period can be repeated by pressing the "START/STOP" button after the alarm sounds.
To set a new timing period, use the "CLEAR" mode (pressing the "MIN" and "SEC" buttons together), and repeat
procedure of "TO SET TIMER" as above.
Note: After battery is inserted, press "CLEAR" (pressing the "MIN" and "SEC" buttons together), to reset before
operating the timer.
INSTRUCTIONS:
T – 1 Timer
MADE IN CHINA
7 43223 00001 2
CEI ONE YEAR LIMITED WARRANTY
CEI warrants this product (except for batteries) to be free from defects in materials and
workmanship under normal use for one years from the date of purchase. CEI will, at its option,
repair or replace the product free of charge. The warranty does not apply to damage caused by
negligence, accident, misuse or repair. No responsibility is assumed for any incidental or
consequential damages. Some states do not allow limitations on how long an implied warranty lasts
and some states do not allow the exclusion or limitation of incidental or consequential damages, so
that the above limitations may not apply. This warranty gives specific legal rights, and other rights
may exist which vary from state to state. To obtain warranty service send the unit prepaid and
insured, with dated proof of purchase, to: CEI, 550 Patrice Place, Unit C, Gardena, CA 90248.
  • Page 1 1
  • Page 2 2

Ultrak T-1 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI