multicomp pro LTS Operating instructions

Hello! I have reviewed the user manual for the PULSE Laptop Stand LTS. This document provides comprehensive assembly instructions for different mounting options, including table top, C-clamp table, and DJ coffin mounts. I can answer questions about adjusting the stand's height, assembling the components, and more specifically details about mounting options. Please ask if you have any questions.
How can I adjust the height of the stand?

How do I assemble the stand?

What tools do I need to assemble the stand?

Multi-Purpose Laptop Stand

Model: LTS

www.pulse-audio.co.uk

CongratulationsonyourpurchaseofthePULSELTS,Multi‐PurposeLaptopstand.

Pleasereadthefollowingassemblyinstructionscarefully.Wehopeyouenjoyyour

newpurchase!



Parts:Removeallpartsfromtheboxandidentifythem.



RequiredTools:Philipsheadscrewdriver.

SupportAssembly:



1.TakeoneoftheUpperSupportsandplaceitoverthe

outsideofoneoftheLowerSupports(SeeFigureA).Align

theUpperSupportholeswiththeLowerSupportmounting

holestoobtainthedesiredheight.



2.Oneatatime,placeoneknobthroughthemounting

holes(mustbespacedatleast2holesapart).



3.TakeaStabilizerBarandscrewthetopknobintotheend

oftheStabilizerBar.Repeatwithbottomknob.



4.Install1inchspacersoneachStabilizerbartoincrease

standwidth.RepeatStep3withtheotherUpperSupport

andLowerSupportfortheoppositesideofthestand(see

FigureB).Tightenallknobstominimizewobble.



5.Dependingonuseofstand,pleaserefertooneofthe

followingmountoptionsbelow.



TableTopStand:



1.Usingfour(4)A‐screwsandwashers,attachtheflatfootbarto

thelowersupport.(SeeFigureC)



2.Repeatstep1ontheoppositesideofthestand.



C‐ClampTableMount:



1.Turntheclampsothattheknobfacesdown.Usingtwo(2)

B‐screwsandwashers,attachtheclamptothelowersupport.

(SeeFigureD)



2.Repeatstep1ontheoppositesideofthestand.



C‐ClampDJCoffinMount:



1.Turntheclampsothattheknobfacesout.Usingtwo(2)

B‐screwsandwashers,attachtheclamptothelowersupport.

(SeeFigureE)



2.Repeatstep1ontheoppositesideofthestand.

multicomp pro LTS Operating instructions

Other documents