2. Haworth
  3. 7021-6641c

Haworth 7021-6641c Operating instructions

  • Hello! I have reviewed the installation instructions for the Haworth Wainscot kit model 7021-6641. This document explains how to install the wainscot panel, retaining clips and top rail without using any tools. I can answer questions about the document.
  • Do I need special tools to install the wainscot kit?
    Is there anything specific I should be aware of for 42" to 60" wainscot kits?
    How should the wainscot panel be positioned?
    How to install top rail?
CUSTOMER SERVICE PHONE: 1-800-426-8562
Part No: Rev:
Page:
E.C.O. No: 401-049 1 of 1 7021-6641 C
No Tools Required
1
Wainscot
Panel
Bottom
Panel Frame
NOTE!
42" through 60" wainscot kits require third retaining clip. Fabric
wainscot kits produced after March 1994 already have retaining
clips on them.
2
Install retaining clips Install wainscot panel
Wainscot
Panel
Bottom
Panel Frame Retaining
Clip
Glazed
Panel
NOTE!
Retaining
Clip
3Install top rail
NOTE!
Push top rail down until wainscot panel is fully
seated into top rail channel. Be careful not to
scratch the side frame rail surfaces. Repeat all
steps for other side of glass panel.
Insert top rail
into glass
slot
Top Rail
WAINSCOT KIT
Installation Instructions
Position the panel so that grooves on top and bottom edges are
closest to the front face with cathederals pointing up.
/