REXTON M-Core CROS iX-CIC User guide

Type
User guide

This manual is also suitable for

M-Core CROS iX-CIC
USER GUIDE
2
CONTENT
Welcome    4
Your CROS transmitter    5
Components and names  7
Signal tones  8
Batteries    9
Battery size and handling tips  9
Replacing batteries  10
Daily use    11
Turning on and o  11
Inserting and removing the transmitter  11
Maintenance and care    15
Transmitter  15
Ear pieces  16
Professional maintenance  19
Further information    20
Explanation of symbols  20
Operating, transport and orage conditions  21
Troubleshooting  22
Disposal information  22
Conformance information  23
Country-specic information  25
3
Important safety information    26
Personal safety  26
Product safety  29
Service and warranty  35
4
WELCOME
Thank you for choosing one of our hearing inrument
accessories.
This guide, along with support from your Hearing Care
Professional, will help you underand the advantages
and greater quality of life this accessory oers.
CAUTION
It is important to read this user guide thoroughly
and completely. Follow the safety information to
avoid damage or injury.
5
YOUR CROS TRANSMITTER
CROS solutions are designed for people with profound
hearing loss in one ear which can not be aided with a
hearing inrument. A CROS transmitter worn on this
ear captures sound from this side and transmits it to
the hearing inrument on the other ear. This allows the
wearer of the hearing inrument to hear sounds from
both sides.
CROS transmitter hearing inrument
6
Two solutions are available:
CROS solution:
For people with normal hearing in one ear and
profound hearing loss in the other. Sounds from the
side with hearing loss are captured and transmitted
wirelessly to the good‑hearing side.
BiCROS solution:
For people with profound hearing loss in one ear
and less severe hearing loss in the other. Sounds
from the more severe hearing loss side are captured
and transmitted wirelessly to the better‑hearing side.
The hearing inrument processes and amplies the
sounds from both sides.
The CROS transmitter works with our specic wireless
hearing inruments. Your Hearing Care Professional will
advise you on the compatible models.
NOTICE
This user guide only applies to the CROS
transmitter. Your hearing inrument has a separate
user guide.
7
COMPONENTS AND NAMES
Ear piece (Click Sleeve)
Microphone
Battery compartment
(on/o switch)
Removal cord
You can use the following andard ear pieces:
Standard ear pieces Size
Click Sleeve (vented or
closed)
Click Dome™ single
(open or closed)
Click Dome semi‑open
Click Dome double
You can easily exchange the andard ear pieces. Read
more in section "Maintenance and care".
8
SIGNAL TONES
Signal tones of the CROS transmitter ‑ like a low battery
beep - are sent to the hearing inrument.
Ask your Hearing Care Professional to congure the
signal tones.
9
BATTERIES
When the battery is low the sound becomes weaker
or you will hear an alert signal. The battery type will
determine how long you have to replace the battery.
BATTERY SIZE AND HANDLING TIPS
Ask your Hearing Care Professional for recommended
batteries.
Battery size: 10
The "battery low" signal of the CROS transmitter and
the "battery low" signal of the hearing inrument have
dierent melodies.
Always use the correct battery size for your device.
Remove the batteries if you intend not to use the
device for several days.
Always carry spare batteries.
Remove empty batteries immediately and follow your
local recycling rules for battery disposal.
10
REPLACING BATTERIES
Removing the battery:
XOpen the battery
compartment.
XRemove the battery by
hand.
Inserting the battery:
XIf the battery has a protective lm, remove it
only when you are ready to use the battery.
XInsert the battery with the
"+" symbol facing upwards.
XCarefully close the battery compartment. If you feel
resiance, the battery is not inserted correctly.
Do not attempt to close the battery compartment by
force. It can be damaged.
11
DAILY USE
TURNING ON AND OFF
XTurning on: Close the battery compartment.
The transmitter turns on after a delay of several
seconds (power-on delay).
XTurning o: Open the battery compartment.
INSERTING AND REMOVING THE TRANSMITTER
CAUTION
Risk of injury!
XAlways wear the device with an ear piece.
XMake sure that the ear piece is completely
attached.
Inserting:
XIdentify right and left device so that you insert it in the
correct ear. The labeling or the color of the device
indicates the side:
red color, imprinted "R" = right ear
blue color, imprinted "L" = left ear
12
XTake care that the flap of the Click Sleeve matches the
line printed on the device.
correct incorrect
XHold the device correctly before inserting it: Pay
special attention to the removal cord indicating the
bottom. The arrow which is printed on the device has
to point upwards.
L R
13
XCarefully push the device
into the ear canal.
XTwi it slightly until it sits
well.
Open and close
your mouth to avoid
accumulation of air in the
ear canal.
CAUTION
Risk of injury!
XInsert the device carefully and not too deeply
into the ear.
It may be helpful to insert the right device with
the right hand and the left device with the left
hand.
If you have problems inserting the device,
use the other hand to gently pull your earlobe
downwards. This opens the ear canal and eases
insertion of the device.
14
Removing:
NOTICE
Never pull on the battery compartment door to
remove the device. This could damage the device.
XPush lightly on the back of your ear to loosen the
device.
XRemove the device by pulling the removal cord
towards the back of your head.
CAUTION
Risk of injury!
XIn very rare cases the ear piece could remain
in your ear when removing the device. If this
happens, have the ear piece removed by a
medical professional.
Clean and dry your device after usage. Read more in
section "Maintenance and care".
15
MAINTENANCE AND CARE
To prevent damage it is important that you take care of
your device and follow a few basic rules, which will soon
become a part of your daily routine.
TRANSMITTER
DRYING AND STORAGE
XDry your device overnight.
XFor longer periods of non-use, ore your device in a
dry environment with an open battery compartment
and the batteries removed.
XAsk your Hearing Care Professional for more
information.
CLEANING
Your device has a protective coating. However, if not
cleaned regularly you may damage the device or cause
personal injury.
XClean your device daily with a soft, dry tissue.
XNever use running water or immerse the
device in water.
XNever apply pressure while cleaning.
XAsk your Hearing Care Professional for recommended
cleaning products, special care sets, or more
information on how to keep your device in good
condition.
16
EAR PIECES
CLEANING
Cerumen (ear wax) may accumulate on the ear pieces.
This may aect sound quality. Clean the ear pieces daily.
XClean the
ear piece right
after removal
with a soft and
dry tissue.
This prevents
that cerumen
becomes dry
and hard.
XSqueeze the tip of the ear piece.
EXCHANGING
Exchange andard ear pieces approximately every
three months. Replace them sooner if you notice
cracks or other changes. The procedure for exchanging
andard ear pieces depends on the type of ear piece.
In section "Components and names", your Hearing Care
Professional has marked your type of ear piece.
17
EXCHANGING CLICK SLEEVES
XGrip the Click Sleeve with your ngers and pull it o. If
you cannot grip it, turn it inside out and then pull it o.
XTake particular care that
the new Click Sleeve
clicks noticeably in place.
click
18
XWhen inalling the new Click Sleeve, take care that
the flap of the Click Sleeve matches the line printed on
the device.
correct incorrect
19
EXCHANGING CLICK DOMES
If you have problems removing the old Click Dome, follow
the inructions on the packaging of the Click Domes.
XTake particular care that the
new Click Dome attaches
with a noticeable "click".
PROFESSIONAL MAINTENANCE
Your Hearing Care Professional can perform a thorough
professional cleaning and maintenance.
Ask your Hearing Care Professional for your individual
recommendation of maintenance intervals and for
support.
20
FURTHER INFORMATION
EXPLANATION OF SYMBOLS
Symbols used in this document
Points out a situation that could lead to serious,
moderate, or minor injuries.
Indicates possible property damage.
Advice and tips on how to handle your device better.
Symbols on the device or packaging
CE compliance label, conrms compliance with
certain European Directives, refer to section
"Conformance information".
EMC and radio communications
compliance label Auralia, refer to section
"Conformance information".
Indicates the legal manufacturer of the device.
Do not dispose of the device with general
domeic wae. Read more in section
"Disposal information".
Read and follow the inructions in the user
guide.
Medical device
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32

REXTON M-Core CROS iX-CIC User guide

Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI