Thorn Altis Gen5 / ALG5 JUNCTION BOX GB TO 3X1 MODULE Installation guide

Type
Installation guide
Montážní návod
CZ
Istruzioni di montaggio
IT
Szerelési útmutató
HU
Notice de montage
FR
Asennusohje
FI
Paigaldusjuhend
EE
Monteringsvejledning
DK
Montageanleitung
DE
Montavimo Instrukcijos
LT
Installation instructions
UK
Installationsanvisning
SE
RU
Instrukcja montazu
PL
Monteringsanvisning
NO
Instalacijas instrukcija
LV
96679405-00 03/2022
ALTIS G4
TYPE : ILF SPARE JUNCTION BOX ALTIS G4G5
CLASS I
IP66 / IK08
LED
The luminaire with clear optic should be
positioned so that prolonged staring into
the luminaire at a distance <2m is not expected Caution, risk of electric shock
Danger, risque de chocs électriques
T20/T25
19/30/36
The light source contained in this luminaire
shall only be replaced by the manufacturer or
his service agent or a similar qualified person.
ALG4 144L (LB)
ALG4 288L (LB)ALG4 432L
ALG4 288L
Extreme caution : Do not connect any LED CONNECTION
wire (high voltage) inside NTC connector !! It could result in
a critical failure and damage irreversibly the ALTIS luminaire
(7*) Optionnal : NTC connection (thermal monitoring).
Cable 9x cores or above is recommended (ex : H07 RN-F 9G1,5mm²)
2
1
96679405-00 03/2022
T25
1
4
2
3
1-TOP BRICK 1-TOP BRICK
2-MIDDLE BRICK
2-MIDDLE BRICK
3-BOTTOM BRICK 3-BOTTOM BRICK
2
1
130/36
3
Or
On request
THORN
4
3
96679405-00 03/2022
3
T25
T25
2Nm
3
1
2
2
4
1
2
Retaining washer
Or
On request
THORN
6
5
96679405-00 03/2022
ALG4 288L (LB)ALG4 288L
T25
1
3
4
1-TOP BRICK
2-MIDDLE BRICK
NTC
G/Y
GREY
BLACK
BROWN
1-
10 15mm
1+
2
1-TOP BRICK
2-MIDDLE BRICK
Extreme caution : Do not connect any LED CONNECTION
wire (high voltage) inside NTC connector !! It could result in
a critical failure and damage irreversibly the ALTIS luminaire
(7*) Optionnal : NTC connection (thermal monitoring).
Cable 9x cores or above is recommended (ex : H07 RN-F 9G1,5mm²)
1 Nm
1-TOP BRICK 2-MIDDLE BRICK
NTC
-
+
8
7
96679405-00 03/2022
1-TOP BRICK 2-MIDDLE BRICK
3-BOTTOM BRICK
T25
1
3
4
1-TOP BRICK
1-TOP BRICK
2-MIDDLE BRICK
2-MIDDLE BRICK
3-BOTTOM BRICK
3-BOTTOM BRICK
NTC
G/Y
GREY
BLACK
BROWN
1-
10 15mm
1+
1
2
ALG4 432L
Extreme caution : Do not connect any LED CONNECTION
wire (high voltage) inside NTC connector !! It could result in
a critical failure and damage irreversibly the ALTIS luminaire
(7*) Optionnal : NTC connection (thermal monitoring).
Cable 9x cores or above is recommended (ex : H07 RN-F 9G1,5mm²)
NTC
-
+
1 Nm
9
96679405-00 03/2022
2 Nm
T25
4
4
1
2
3
100
10
Ø min = 1,0 mm²
Ø typ = 1,5 mm²
Ø max = 2,5 mm²
OK
30/36
3Nm
+1 +3 -3 +2 -2
NTC
-1
Extreme caution : Do not connect any LED CONNECTION
wire (high voltage) inside NTC connector !! It could result in
a critical failure and damage irreversibly the ALTIS luminaire
(7*) Optionnal : NTC connection (thermal monitoring).
Cable 9x cores or above is recommended (ex : H07 RN-F 9G1,5mm²)
1 2 3 4 5 6 7* G/Y
1 2 3 4 5 6 7
-Remplacer toute protection fissurée.
-Les luminaires classe II doivent être
installés de façon à ce que la partie
métallique ne soit pas en contact avec
l'installation électrique connectée à la terre.
ATTENTION:Les luminaires classe I
doivent être reliés à la terre.
-Ce luminaire fonctionne à une tension
nominale qui doit être coupée avant
toute intervention sur l'appareillage.
-Toute modification de cet appareil est interdite.
-Respecter la distance minimale par rapport
aux objets éclairés définie par ce sigle.
-Ersätta alla spräckta skyddsplåtar.
-Klass II armaturer måste installeras så
att nakna metalldelar i armaturen inte
är i kontakt med någon elektrisk
installation,kopplad till en skyddledare.
VARNING:Klass I armaturer måste vara
jordade.
-Denna armatur fungerar med högspänning
som måste vara frånslagen fore ingripande
i driftdonen.
-Alla ändringar i denna armatur är förbjuden.
-Sostituire sempre tutte le protezioni
danneggiate.
-Gli apparecchi in classe II devono essere
installati in modo che le parti metalliche
non siano in contatto con apparati elettrici
collegati a terra.
ATTENZIONE:Gli apparecchi in class I
devono essere collegati a terra.
-Questo apparecchio funziona a tensione
nominale,questa deve essere interrotta
prima di ogni intervento sul gruppo di
alimentazione.
-Ogni modifica dell' apparechio à proibita.
-Replace any cracked protective shield.
-Class II luminaires must be installed so
that exposed metal work of the luminaire
is not in contact with any part of the
electrical installation connected to a
protective conductor.
WARNING:Class I luminaires must be
earthed.
-This luminaire operates at mains voltage
which must be switched off before
intervention in control gear.
-Any modification to this luminaire is forbidden.
-Lighted objects nearer than the minimal
distance in the is forbidden.
-Ersetze jede gebrochene Schutzscheibe.
-Schutzklasse II Leuchten müssen so
installiert werden,daß berührbare
Metallteile nich mit einem,an dem
Schutzleiter angeschlossenen Teil der
elektrischen Installation in Kontakt
kommen können.
ACHTUNG:Schutzklasse I Leuchten
müssen geerdet sein.
-Diese Leuchte wird mit Netzspannung
betrieben.Bevor Eingriffe am
Vorschaltgerät vorgenommen werden
sowie vor Wartung und Installation,ist die
Versorgungsspannung abzuschalten.
-Jede Änderung an dieser Leuchte ist verboten.
FRANCAIS SVERIGE ITALIANO
-Rikkoontunut suojalasi vaihdettava
välittömästi uutsen vastaavaan.
-Asennettaessa suojausluokan II valaisinta
on peruseristetyn johdon ja kosketeltavien
metalliosien välinen kosketus tehokkaasti
eristettävä.
VAROITUS:
Suojausluokan I valaisin
täytyy maadoittaa.
-Verkkojännite on kytkettävä pois ennen
valaisimen huoltotoimenpiteitä.
-Valaisimen rakennetta el saa muuttaa.
SUOMI
ENGLISH DEUTSCH
m m
m m
m
m
Thorn Lighting is constantly developing and improving its products. The right is reserved to change specifications without prior notification or public announcement.
© Thorn Lighting
96679405-00 03/2022
- To ensure maintaining the best system performances, we advice to switch on
the system "At least one night hour per month".
- corrosion environment from C1 to C5 according to standard ISO9223
except gear Box ALG4 GB LE 432L corrosion environment from C1 to C3
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Thorn Altis Gen5 / ALG5 JUNCTION BOX GB TO 3X1 MODULE Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI