Page is loading ...
ASSEMBLY INSTRUCTIONS
CARE
REPLACEMENT PARTS
MODEL 33046 10’ X 10’
DO NOT LEAVE YOUR CANOPY SET UP IN DIRECT SUNLIGHT LONGER THAN NECESSARY. THE SUN’S ULTRAVIOLET (UV) LIGHT
DEGRADES ALMOST EVERY FABRIC AND MATERIAL. IF LEFT IN SUNLIGHT FOR PROLONGED PERIODS OF TIME, FABRIC WILL
FADE AND WEAKEN. DO NOT STORE CANOPY ON CONCRETE FLOOR. DO NOT SPRAY THE CANOPY WITH INSECTICIDE.
EXERCISE CARE WHEN USING ELECTRIC DEVICES IN AND NEAR CANOPY.
Although our tents, screen houses and canopies are constructed to rigid specifications, periods of wind or rain soaking the ground may
loosen the stakes and cause the uprights to sink into the ground. This will weaken the rigidity of the overall structure. Water pockets may
also form in the roof if the unit is not assembled taut, possibly causing broken frames and torn fabric.
Send your request for parts to:
American Recreation Products, Inc.
6235 Lookout Road
Boulder, CO 80301
MODEL NO. 33046, 10’ x 10’
DESCRIPTION
Replacement Skin
Carry Bag
Stake
Pin Stake
Guy Rope
33046SKN
33046BAG
NAIL STAKE
PIN STAKE
A1001
A
B
C
1
1
4
4
4
PART NO.
KEY
NO.
QTY
REQ
B - Carry Bag
C - Nail Stake
If you have questions or need to order a part, call 1-800-325-4121 or send an email to [email protected].
Have your model number or part number ready when you call. DO NOT ORDER BY REFERENCE KEY NUMBER.
A - Replacement Skin
SAFETY WARNING -
DOs AND DO NOTs
EVERYONE WHO USES THIS CANOPY SHOULD READ THIS MANUAL AND BECOME FAMILIAR WITH ALL
SAFETY WARNINGS AND PRECAUTIONS FOR SAFE USE, ASSEMBLY, CARE, MAINTENANCE,
AND STORAGE. KEEP THIS MANUAL SO YOU CAN REFER TO IT LATER.
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
FLAMMABILITY WARNING KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS CANOPY FABRIC
This canopy is made with flame resistant fabric which meets CPAI-84 specification. IT IS NOT FIREPROOF. The fabric will burn if left in continuous contact with any
flame source. The application of any foreign substance to the canopy fabric may render the flame-resistant properties ineffective. For these reasons:
• DO NOT use matches, lighters, stoves, heaters, grills, lanterns, candles, cooking equipment, or other fuel-burning devices inside or
near a canopy.
• DO NOT build fires inside or near canopy.
• DO NOT leave campfires unattended.
Your failure to follow these warnings will cause death, serious injury, or permanent disability to you or others.
PROTECT YOUR CHILDREN
• DO NOT leave children unattended in camp.
• DO NOT allow children to assemble canopy.
• DO NOT allow children to swing or climb on canopy poles.
Your failure to follow these warnings will cause death, serious injury, or permanent disability to your children.
DANGER
DANGER
DANGER
ASSEMBLY INSTRUCTIONS
MODEL 33046 10’ X 10’
IMPORTANT: Two adults are required when assembling this canopy. The canopy
may be damaged if unbalanced forces act on the frame or roof fabric during
assembly of the canopy,
NOTE: Choose a level surface to set up your canopy.
STEP 1: Remove canopy from carry bag.
STEP 2: Place the frame on its feet. With an adult on opposite corners of the canopy
frame, lift the frame slightly off the ground and expand it by walking backwards
until the frame is completely extended.
STEP 3: Push up on each frame corner till the clip locks “click”
into place. Make certain each frame corner is locked
into place.
STEP 4: Unfold the canopy skin and cover the frame with the canopy fabric. Fit the
canopy skin corners over the frame corners. Attach the Velcro patches on the
underneath side of the canopy corners to the Velcro patches at each frame corner.
STEP 5: Now raise the canopy to the desired height by extending the telescoping
legs until the safety clip lock snaps into place. Extend each leg one notch at a
time, making sure all four legs are level, before proceeding to the next notch.
STEP 6: Secure the canopy skin to the frame by
wrapping the Velcro tape around the frame poles,
on the underneath side of the canopy.
STEP 7: There are holes in the metal plates at the lower ends
of the canopy legs. Insert the nail stakes into the holes on
the plate and hammer stakes into the ground.
NOTE: Canopy can also be attached to wooden deck
with nails or bolts.
STEP 8: Guy ropes are included for additional stability for your
canopy. Extend the guy ropes which are attached to the
canopy corners. Make a loop at the opposite end of the
guy rope by using slider (as shown). Place loop over
one of the smaller metal pin stakes and hammer
stake into the ground. Adjust slider to make
guy rope tight.
NOTE: In extremely windy conditions, the guy
ropes and pegs may not be sufficient to support the canopy.
Dismantle canopy immediately in adverse weather conditions
Assembled canopy
should appear
as shown.
NOTE: A storage pocket is included
which can be attached to any corner of the
canopy to hold small camping items within easy reach
and up, off the ground.
NOTE: To dismantle canopy, follow the above steps in reverse order.
• Unfasten the Velcro tab fasteners along the eaves and corners of the canopy.
• Lower the canopy by pushing the release button on the canopy leg poles.
Lower canopy one notch at a time so all four legs are level, before proceeding
to next notch.
• Remove canopy skin from frame and fold skin into equal parts to distribute
the bulk.
• Fold canopy skin to match the length of the carry bag.
• Release the clip locks at each of the frame legs and compress frame. One
person should be on each corner on the canopy frame, lifting the frame legs
off the ground and walking the frame slowly and evenly till the frame is
completely compressed.
• Place frame, stakes and canopy skin back into the carry bag and zip carry bag
closed, by using the expandable zipper.
MAKE SURE THE CANOPY IS CLEAN AND DRY BEFORE STORING.
CANOPY NOT INTENDED FOR PERMANENT OUTDOOR USE.
/
