RedPort XTRACKER IR Quick start guide

  • Hello, I'm a chat assistant that has read the RedPort XTracker IR Quick Start Guide. I understand the device is designed for tracking purposes and can be used on vehicles, ships, or buildings and the document contains the mounting and power instructions. I’m ready to assist you with any questions you might have about the XTracker IR.
  • What is the minimum voltage and amperage required?
    Does the product come with a mounting bracket?
    How far away should the tracker be installed from radar?
XTracker IR Quick Start Guide
Physical Setup
1. Install Tracker with any standard 1 wide, 14 thread per inch (TPI) marine grade
antenna mount. We do not include an antenna mount with this product. Various
mounting options can be found at your local marine supply store.
2. Run the power cable to your preferred power location. Unit is not protected
against reverse polarity. Ensure correct wiring before applying power.
Incorrect power will void warranty.
Vehicle Mounting
When mounting on a vehicle, make sure there is no large
obstruction blocking its view of the sky.
Run power cable into the cabin of the vehicle and plug it into a
power source.
Recommended Accessory: 12V “cigarette plugadapter (sold separately).
Ship Mounting
The Tracker can be installed in many different locations on board.
Make sure it has a clear view of the sky and there is no large
obstruction blocking its view of the sky.
The tracker must not be on the same plane as the radar equipment.
For best performance the tracker should be installed 2.5 meters (about
8 ft) away from all radar or other RF devices that may cause
interference.
You will notice an arrow on the bottom of the tracker. This arrow must
face the bow of your vessel.
Building Mounting
When mounting on a building, make sure that there is
no obstruction blocking its view of the sky.
Run power cable from the dome to your preferred
powering location.
X-Tracker IR Quick Start
Mount the unit outside with a clear view of the sky (Note: Do NOT place unit
near microwave emitting devices). X-Tracker comes with a 12v, 2amp AC plug
and a 2.1mm barrel adapter used for hard wiring to a DC circuit. The XTracker
requires 12 volts, 1 amp at minimum to operate. The XTracker also comes with
20 meters of cable. Apply power and position reports will show on your map.
Technical Specs
Power
12V Power
Internal Battery Life
2500 mAh, 3.7 V internal battery
IP Rating
IP67
Operating Temp
-22 F to 158 F (-30 C to 70C)
Speed Warning
Accuracy degrades after 700 mph (Mach 1)
Height
7.28 in Dia (185 mm)
Width
7.08 in high (180 mm)
Weight
4 Lbs (1.81 kg)
Trouble Shooting
It may take up to two hours for your first position to register on our tracking site. If your position
does not appear within that time, please contact our support team. For any other questions, help with
installation, or activation, please contact support at support@globalmarinenet.com or 877-379-8723.
XTracker IR Tracking Service is required
to use this device.
Please contact Global Marine Networks for
Service activation.
www.globalmarinenet.com
/