DDL-9000 (June, 2001) 2/2
To mount the optional devices onto the machine after the setup, the optional PWB A Part No.: M9701-461-0A0 (separately available) will be required.
●The motor acceleration can be selected from three setting
(standard, slow, rapid) by operator's preferance.
●The function-setting switch is provided with two new
capabilities: reverse feed and repeat. In addition, the switch
has a reset capability to restore the machine to the default
settings.
SC-900
The SC-900 control box offers further upgraded capabilities.
●With this control panel, two kinds of programs combining
as many as 15 steps can be established.
●This control panel has an expanded range of functions such
as teaching sewing, a function used to establish the number
of stitches during sewing.
CP-360D
●Four different kinds of pattern sewing are possible:
automatic back tack, constant-dimension sewing,
rectangle-shape sewing, and multi-layer stitching.
As many as 19 stitches can be established for automatic
back tack (single or double).
✽“Without control panel” can also be specified.
CP-160D
The control panel can be selected according to the process.
●Designated on the control box.
●Operative when the machine is equipped with a remaining bobbin thread detector
(AE: optional).
●Operative when the machine is equipped with a material edge sensor (ED: optional).
OPTIONS
CONTROL PANEL SPECIFICATIONS
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
Function
Power indicator lamp (LED)
Max. speed limitation variable resistor
Thread trimming prohibition switch
Soft-start
Automatic count back
Material edge sensor ON/OFF switch
Function of detecting the remaining amount
of bobbin thread
Automatic thread trimming switch
Back tack pattern switch
Overlapped stitching pattern switch
Bobbin thread counter
Needle up/down compensating switch
One-shot automatic stitching switch
Double back tack switch
Key lock
Constant-dimension stitching pattern
Programable seam length
Production counter
Programmed stitching pattern
Combined stitching pattern switch
Re-sewing switch
Teaching switch
Presser foot lifting time setting switch
CP-160D
Pictograph
CP-360D
Model Description
AK118
AE-8
ED-4
Part No.
This switch, mounted on the reverse feed switch, enables handy control of various functions.
It is especially effective when operating the machine while standing.
When the amount of remaining bobbin thread reaches the setting, the buzzer will sound to warn
the operator not to press, on the front part of the foot pedal. With this function, the operator
doesn’t have to look away from the sewing work to check the bobbin thread.
(Only supported by the minute-quantity lubricating type machine)
When the sensor detects a material edge, it immediately stops the sewing machine and actuates
the thread trimmer. This enhances productivity by allowing the operator to conduct sewing
work without running to look out for missing stitches.
This device can be installed on the back of the face plate. It is very convenient for frequent use.
Feature
236-32656
GAE-080000A0
236-11056
Auto-lifter
Optional switch
Remaining bobbin
thread detector
Material edge sensor
Micro-lifter (asm.)
