Speakman S-3762-E User manual

Category
Sanitary ware
Type
User manual

This manual is also suitable for

Instructions for Models:
S-3762
S-3762-HS
S-3762-E
S-3762-E-HS
What You Need To Know:
Tools:
Required:
*Adjustable
Wrench
*Groove Joint
Plier
*Phillips
Screwdriver
*Teflon Tape
Helpful:
*Supply Lines *Basin Wrench
*Pipe Wrench *Hacksaw *Tubing Cutter
Important Notes:
Be sure to read instructions thoroughly before
beginning installation. Do not overtighten any
connections or damage may occur. This faucet
has an operating range of 20-80 psi.
Safety Tips:
Cover your drain to prevent loss of parts.
Be sure to wear eye protection while cutting pipe.
Maintenance:
Your new Kitchen Faucet is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. Avoid
abrasive cleaners, steel wool and harsh chemicals
as these will dull the finish and void your warranty.
Insert the side sprayer (1) hose down through
the sprayer support (2) and sink. Align the tabs
(3 & 4) on the quick connects (5). Push the
quick connector housing firmly upward and
snap it onto the receiving tube tab. Pull down
moderately to ensure the connection has been
made. If it is necessary to remove the quick
connector, squeeze the tabs on the hose, and
pull down to disconnect.
Place the faucet assembly (1) in position on the
sink. Secure the faucet assembly (1) to the sink
using the mounting nuts (2) provided. Hand
tighten only.
NOTE: If the sink is uneven, use silicone under
the gasket (3).
*Utility Knife *Eye Protection
What You Need To Know:
Shut off water supply. Remove old faucet. Clean
sink surface in preparation for new faucet. Place
the gasket (1) on the bottom of the new faucet
assembly (2).
If your model has a side sprayer, proceed to
step 2. If your model does not have a side
sprayer, skip to step 4.
Insert the sprayer support (1) through the far
right hole on the sink. Screw the sprayer
mounting nut (2) onto the sprayer support (1)
shank from underneath the sink, and hand
tighten.
2
1
2
1
Make connections to water lines. Use 1/2" IPS
faucet connections (1) or use the supplied
coupling nuts (3) with 3/8"O.D.ball-nose
risers (2). Use wrenches to tighten connections.
Do not overtighten.
2
3
1
2
3
1
5
4
2
3
1
Need Help?
For additional assistance or service call:
SPEAKMAN Company
400 Anchor Mill Road
New Castle, DE 19720
PHONE: 800-537-2107
EMAIL: customerservice@
WEB: www.speakman.com
92-S-3762-R3
speakman.com
RPG41-0107
RPG49-0004
RPG05-0797 (1.5GPM)
RPG05-0822
After installation is completed, remove aerator.
Turn on water supply and allow both hot and
cold water to run for at least one minute each.
While water is running, check for leaks. Replace
aerator Do not lose the gasket (1) in the aerator.
IMPORTANT:
RPG05-0852
RPG01-0054
2.01''
[51.0mm]
BOWL
1 1/16''
[27.00mm]
2''
[51.00mm]
Ø1 3/16''
[Ø30.00mm]
4''
[101.60mm]
Ø1 7/16''
[Ø37.00mm]
8"( 203mm)
DECK PLATE
8''
[203.19mm]
2 1/8''
[54.00mm]
4''
[101.60mm]
10 7/16''
[264.74mm]
8 15/16''
[226.22mm]
15/16-27UNS-2A
2 1/8''
[54.00mm]
6 9/16''
[166.77mm]
7 11/16''
[194.57mm]
1/2''-14NPSM-2A
1/8''-LEAD.1/16''PITCH
2''
[50.79mm]
5 15/16''
[150.32mm]
8''
[203.17mm]
8''
[203.20mm]
10 1/8''
[257.00mm]
1 5/16''
[33.13mm]
RPG05-40049 (1.8GPM)
  • Page 1 1
  • Page 2 2

Speakman S-3762-E User manual

Category
Sanitary ware
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI