Matrix Rower-03 Owner's manual

Matrix
Brand
Matrix
Model
Rower-03
Type
Owner's manual

This manual is also suitable for

1 | Posted 12/6/2018 by RT
Installation Guide:
Target Training Console Wi-Fi Module
PROCEDURE
Follow the instructions below to install Wi-Fi in a Target Training Console. Wi-Fi is required to track
the unit in Asset Management.
Wi-Fi Kit Components
1. Make
sure the console is not connected to any source of power.
2.
Remove the 4 screws to separate the front and back console covers.
3. Put the Wi-Fi board in place and attach it with the two screws provided.
2 | Posted 12/6/2018 by RT
4.
Attach the antennas to the inside of the back cover, aligning them with the embossed lines.
5. Apply tape to secure the antennas.
6. Twist the wires together and connect the antenna ends to the Wi-Fi module.
3 | Posted 12/6/2018 by RT
7. Put the back console cover in place and attach it with the screws.
8. Attach the console to the unit and power the console on.
9. Configure the following information in the console. (See the Service Guide for setup
instructions.)
• Asset Management and Workout Tracking
• Network Setup
10. After configuring the console with a valid Facility ID and valid Frame and Console Serial
Numbers, a machine record will be inserted in Asset Management when one of the following
occurs:
• a network connection is established
• a workout of >1 minute is performed
• power is cycled
In the event that a machine record is not inserted in Asset Management following one of the
three actions above, contact Matrix Customer Tech Support.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Matrix Rower-03 Owner's manual

Matrix
Brand
Matrix
Model
Rower-03
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents