2. AccuBANKER
  3. AccuStand

AccuBANKER AccuStand Installation guide

  • I have reviewed the AccuSTAND installation guide, which details how to set up the metal stand for detector models D470, LED420, LED425, LED430, LED440, and D585. The guide provides instructions for installing the stand on both vertical and horizontal surfaces, including information on parts required and proper fastening procedures. I am ready to answer any questions you may have about the installation process.
  • How many holding screws are needed for installation?
    How many rubber feet are included?
    How many thumb screws are needed for D585 model?
7104 NW 50 Street, Miami, FL 33166 USA • 1-888-993-2228 •
www.AccuBANKER.com
AccuSTAND
Installation Guide for: D470 • LED420 • LED425 • LED430 • LED440
Parts needed
Vertical
surface installation
Horizontal
surface installation
1. Metal stand (1pc)
2. Holding screws (4pcs)
3. Rubber feet (2pcs)
4. Thumb screw * (1-2pcs)
*2pcs needed for D585 model only
5. Guider pole (1pc)
6. Guider knob (1pc)
1. In the location where the detector will be
installed, make two point marks 85 mm
from each other Fig. 2, hole D in a horizontal
position to install the holding screws.
2. Tighten the holding screws into the
surface/wall to support the metal base.
3. Proceed to set up the metal base with
the detector as described in the instructions
below (horizontal surface installation).
1. Place the rubber feet into the two holes
labeled C in Fig. 1
2. Screw the Guider pole into the top of the
base in hole A indicated in Fig. 1. Tighten the
mounting Guider knob into the Guider pole.
3. Insert the Guider pole into hole E located at
the base of the detector Fig. 3. Attach the
Thumb screw to secure the base of the unit
as shown in Fig. 4, using threaded hole F
indicated in Fig. 3.
45°
15°
Fig. 3Fig. 4
Fig. 2
B
D
C
E
E
F
F
70
85
44.7
120
150
50
A Fig.
1
7104 NW 50 Street, Miami, FL 33166 USA • 1-888-993-2228 •
www.AccuBANKER.com
AccuSTAND
Installation Guide for: D585
Parts needed
Vertical
surface installation
Horizontal
surface installation
1. Metal stand (1pc)
2. Holding screws (4pcs)
3. Rubber feet (2pcs)
4. Thumb screw (2pcs)
1. In the location where the detector will be
installed, make two point marks 85 mm
from each other Fig. 2, hole D in a horizontal
position to install the holding screws.
2. Tighten the holding screws into the
surface/wall to support the metal base.
3. Proceed to set up the metal base with the
detector as described in the instructions
below (horizontal surface installation).
1. Place the rubber feet into the two holes
labeled C in Fig. 1
2. Tighten the two thumb screws into the
metal thread holes located in the bottom of
the unit, labeled E to secure the unit to the
AccuSTAND as is shown in Fig. 4, using the
threaded hole E indicated in Fig. 3.
45°
15°
Fig. 3Fig. 4
E
Fig. 2
B
D
C
70
85
44.7
120
150
50
A Fig. 1
/