JING YI JY-8010-1 User manual

Brand: JING YI

Model: JY-8010-1

Category: Flashlights

Type: User manual

This manual is also suitable for

JY-8010 SERIES

LED BICYCLE LIGHT

User manual

Thank you for purchasing JY-8010 series

Bicycle Light Device.

This user manual has been specially

designed to guide you through the functions

and features of the device.

1. Product general description

● Mode: 100%Brightness-50%Brightness-

Flashing-Off (Press the button to change

the mode ; Press and hold the button for

2 seconds to turn off the light from any

mode)

● Approximately operating times : 4 hours

with 100% brightness , 8 hours with 50%

brightness,and 8 hours with flashing mode.

● Charging time: 3.5 hours

● Anti-reflection optical glass lens,

scratch resistant

● Waterproof grade: IPX4

● High efficiency orange peel reflector

● 6061-T6 Aluminum alloy body, anodized

anti-abrasive finish

● Easy mount O-rings

● Cable length: 65CM

● Automatic shift function: the brightness

will be shifted from 100% to 50% if the

temperature of the device exceeds the

safety temperature. The 100% brightness

mode would return to normal when the

temperature of the device is lower than

the safety temperature. Normally,the

safety temperature would not be exceed-

ed during driving

● 4 stage fuel gauge show the current ba-

ttery capacity

Green —100~75%

Blue — 75~50%

Yellow — 50~25%

Red — 25~5%

Flashing Red — 5% to Off

2. LED specifications

【Light source】CREE XML-T60

【Luminous flux】1000 lumens

【LED lifespan】50,000 hours

3. Battery specifications

● 4*18650 Li-ion batteries: 7.4V/4.4AH

● Batteries lifespan: 500 cycles of charging

and discharging

● The battery capacity will fall by less than

10% after 500 cycles of charging and dis-

charging

● Certifications: CE,UL,TUV,PSE

● Includes a small protection circuit board

with over-charge, over-discharge and sh-

ort-circuit protection function

4. Operation of charging

The battery has been partially charged at the

factory.When charging is needed, please do

as follows:

● Connect the charger to a wall outlet

● Connect the charger to the battery

Red- charging

Green- fully charged

5. JY-8010 series Components

⑴ Head light A ⑷ Battery B

⑵ Head light B ⑸ Charger

⑶ Battery A ⑹ O-rings (2 PCS)

①

②

③

④

⑤

⑥

JY-8010 series include 4 models:

Ⅰ JY-8010A-1：②+③+⑤+⑥

Ⅱ JY-8010-1：②+④+⑤+⑥

Ⅲ JY-8010A-2：①+③+⑤+⑥

Ⅳ JY-8010-2：①+④+⑤+⑥

6. Assembling

(a) Put the O-ring on the head light

(b) Fit the light on the handlebar with the

O-ring

the battery is tightly fastened

(d) Connect the cables of the battery and the

head light

7. Warning

Read instructions carefully before use.

Failure to comply with the safety instructions

may lead to damage to the charger and\or

batteries and may cause serious injury to the

user or other person.

● Keep out of reach of children

● Do not stare at the light source or point

the light against other people’s eyes, as

the powerful light may cause unexpected

eye-injury

● Do not make the battery or the charger

shortcircuit

● New batteries must be fully charged be-

fore they are used for the first time.

● Keep the charger in a dry place,Indoor

use only

● Do not use the device while charging or

touch your device with wet hands

● Do not drop or cause an impact to the

charger or the battery, and never crush or

puncture the battery

● Do not charge the battery with chargers

that are not approved by the manufacturer

● Never dispose of batteries or devices in a

fire

● Never place batteries or devices on or in

heating devices, such as microwave

ovens, stoves, or radiators. Batteries may

explode when overheated.

● Do not touch the body of the light when

the light is turned on. The body of the

light could be overheated

● Battery must be stored in a dry, low tem-

perature place for long-term storage

● Always store the batteries fully charged

● Do not touch the liquid if the battery is

leaking. If contacted, get medical help

right away.

● Prevent batteries from contacting metal

items, as this can create a connection

between the + and – terminals of the

device and lead to temporary or perma-

nent battery damage

● To ensure proper functioning of the ch-

arger, keep the battery and charger free

from dust & dirt. To clean the charger,

disconnect it from the power supply and

use a dry cloth only. Do not attempt to

open the charger.

8. Suggestion

● We recommend that light and battery

should be separated for long-term

storage

● We recommend that the batteries should

be charged every half a year to prevent

over discharge during long-term storage

JING YI JY-8010-1 User manual

Brand: JING YI

Model: JY-8010-1

Category: Flashlights

Type: User manual

This manual is also suitable for

Download PDF

report

JING YI JY-8010-1 User manual

This manual is also suitable for

JING YI JY-8010-1 User manual

Other documents