Gamber-Johnson 7160-0822 Installation guide

Gamber-Johnson
Brand
Gamber-Johnson
Model
7160-0822
Type
Installation guide

This manual is also suitable for

Gamber-Johnson 7160-0822 is a close-to-dash mount for Chevy Tahoe vehicles. It is designed to mount on top of a Gamber-Johnson Chevy Tahoe vehicle specific console box 7170-0237 (2015+). The mount can be used to hold a variety of devices, including keyboards, laptops, and other equipment.

The 7160-0822 mount is easy to install and can be done in a few simple steps. The mount is also adjustable, so you can position it to get the best possible viewing angle.

Here are some of the features and benefits of the Gamber-Johnson 7160-0822 close-to-dash mount:

  • Mounts on top of a Gamber-Johnson Chevy Tahoe vehicle specific console box 7170-0237 (2015+)

Gamber-Johnson 7160-0822 is a close-to-dash mount for Chevy Tahoe vehicles. It is designed to mount on top of a Gamber-Johnson Chevy Tahoe vehicle specific console box 7170-0237 (2015+). The mount can be used to hold a variety of devices, including keyboards, laptops, and other equipment.

The 7160-0822 mount is easy to install and can be done in a few simple steps. The mount is also adjustable, so you can position it to get the best possible viewing angle.

Here are some of the features and benefits of the Gamber-Johnson 7160-0822 close-to-dash mount:

  • Mounts on top of a Gamber-Johnson Chevy Tahoe vehicle specific console box 7170-0237 (2015+)
Rev.C
INST-716
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
Tahoe Close-To-Dash Mount
Form
•DO NOT remove the warning label from the product under any circumstances.
Revision
INSTALLATION INSTRUCTIONS
PS-001
Product
Printing Spec:
7160-0822
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
•You must read and follow all of these installation instructions. Failure to follow the installation
instructions may result in serious bodily injury or death
•DO NOT install or use this assembly in the area in which the airbag on the vehicle may be
deployed. The installer and user of this assembly are responsible for installing and using this
assembly outside the area in which an airbag may be deployed. (See Product Mounting
Disclaimer Below)
•If the installation of the equipment requires that the equipment (or any additional equipment
that is added to the installation) be placed in front of an airbag, the airbag should be
deactivated. In order to secure permission for deactivating the airbag you must contact the
National Highway Traffic Safety Administration at 1-800-424-9393 to gain permission to do so.
If you have any questions or need assistance, call Gamber-Johnson at 1-800-456-6868.
•High speed vehicle turns may cause parts fo the assembly to swivel, interfering with the driver
or other equipment.
•Keep these installation instructions with the product and readily available in the vehicle
for future reference of other users of the product.
•Additional copies of the installation instruction can be obtained from Gamber-Johnson.
If you need assistance or have any questions, go to www.gamberjohnson.com or
call Gamber-Johnson at 1-800-456-6868.
© copyright 2016 Gamber-Johnson
lock washers
Top Plate
1/4-20 x 1.00" long
lock washers, and hex nuts
carriage bolts, flat washers,
1/4-20 x .88" long
socket button head
machine screw and
Close- To-Dash mount
The Chevy Tahoe Close-To-Dash mount (7160-0822) is designed to mount on top of
a Gamber-Johnson Chevy Tahoe vehicle specific console box 7170-0237 (2015 +).
It will not mount on the older model Chevy Tahoe vehicle specific console box
7170-0222 (2007- 2014). Modifying the Close-To-Dash mount or other Gamber-
Johnson products (ie. console boxes other than 7170-0237) to mount the Close-To-
Dash mount will void the warranty on the Gamber-Johnson products.
Attaching the mount to the Console box:
1. Remove the (2) 1/4-20 x .50" long socket head machine screws that hold the top
plate on the right side of the console box.
2. Place the mount into position and attach with the 1/4-20 x .88" long socket
button head machine screws and lock washers found in the hardware bag. These
screws mount in the location the 1/2" long screws were removed in step 1.
3. The top side of the mount is held down with the 1/4-20 x 1.00" long carriage
bolts, flat washers, lock washers, and hex nuts found in the hardware bag.
4. In lieu of the carriage bolts, a motion attachment like the Mongoose (7160-0220)
or the 6" locking slide arm (7160-0500) can be used to mount a keyboard and hold
the Close-To-Dash mount down to the top plate.
Motion Attachment
  • Page 1 1
  • Page 2 2

Gamber-Johnson 7160-0822 Installation guide

Gamber-Johnson
Brand
Gamber-Johnson
Model
7160-0822
Type
Installation guide
This manual is also suitable for

Gamber-Johnson 7160-0822 is a close-to-dash mount for Chevy Tahoe vehicles. It is designed to mount on top of a Gamber-Johnson Chevy Tahoe vehicle specific console box 7170-0237 (2015+). The mount can be used to hold a variety of devices, including keyboards, laptops, and other equipment.

The 7160-0822 mount is easy to install and can be done in a few simple steps. The mount is also adjustable, so you can position it to get the best possible viewing angle.

Here are some of the features and benefits of the Gamber-Johnson 7160-0822 close-to-dash mount:

  • Mounts on top of a Gamber-Johnson Chevy Tahoe vehicle specific console box 7170-0237 (2015+)
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents