Intermec 825-179 Series Operating instructions

Type
Operating instructions
SR61 Belt Holster Instructions
The SR61 belt holster (P/N 825-179-xxx) provides you with a
convenient way to carry the SR61 Cordless Scanner when you are
not using it. The versatility of the holster allows you to use it on
your left or right side whether you want to reach straight down or
across your body for your SR61. These instructions describe how
to configure and wear the belt holster.
To configure the holster
1 Remove the Phillips screw from the mounting bar.
2 Slide the holster cup down and off of the mounting bar.
Mounting
bar
Phillips
screw
Holster
cup
Mounting
bar
Holster
cup
Mounting
loop
3 Insert the mounting bar into the other mounting loop on the
holster cup.
4 Replace the screw in the bottom of the mounting bar.
To put on the holster and belt
1 Slide the holster to the appropriate side of the belt.
2 With the holster on the outside of your thigh, buckle the belt
around your waist.
3 Adjust the belt so it is snug and comfortable for you, and
secure the loose end of the belt in the J-hook.
4 Buckle the leg strap around your thigh.
5 Adjust the leg strap so it is snug and comfortable for you.
SR61 Belt Holster Instructions
*943-023-001*
P/N 943-023-001
Waist belt
buckle
J-hook
Leg
strap
Leg
strap
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2006 Intermec Technologies
Corporation. All rights reserved.
  • Page 1 1
  • Page 2 2

Intermec 825-179 Series Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI