OPERATING INSTRUCTIONS
• Plug the styler into a suitable mains socket
• The styler will be off and the red indicator light will show
• To switch the appliance on, press the ‘l’ button. The on indicator light
will show green
• Select the required heat setting using the temperature dial. There are
25 temperature settings to select from (refer to temperature setting
guide table above). As a general guide, for delicate, ne or coloured
hair, use the lower heat settings. For thicker hair, use the higher
heat settings. Always start with the lowest temperature setting and
increase the level of heat as required
• The appliance will almost instantly heat up to the chosen heat setting
IMPORTANT: The plates will become very hot when the appliance is
heated up. Take care to avoid the hot surfaces of the appliance coming
into direct contact with the skin, in particular the ears, eyes, face and
neck. Always place on a rm surface for safety. Do not place the
appliance on any heat sensitive surfaces
To Style
• Take a section of hair about 4cm wide
• Spray hair with a light hairspray for extra hold if desired
• Place the section of hair between the bottom plate and top barrels of
the styler. For a natural look the styler should be positioned mid-way
down the hair section
• Clamp the styler shut and hold for about 5-8 seconds
• Release the styler from the hair and gently slide down to the next
section. Re-position the styler to overlap the last wave created, to
ensure a continuous wave effect in the hair
• Move down until you have completed the section and tuck tails into
the barrel with a tail comb for a smooth nish
• Repeat as necessary
• Once all the hair has been styled, take random sections from the
top layer and position the styler slightly higher up from the rst wave
created, this will create a natural looking style
NOTE: The bottom plate of the styler has a straight edge so when
styling the top layers of the hair, it is best to hold the waver at a slight
angle to avoid creating obvious lines around the crown
