• Only connect this unit to alternating current and check that the mains supply voltage
corresponds to that indicated on the unit.
• Never immerse this unit in water or other liquids.
• Do not put this unit down where it could fall into water or other liquids.
• Do not try to pull any electrical appliance out when it has fallen into water - disconnect
the plug from the power socket immediately.
• Make sure the unit is perfectly dry before using it.
• Do not put the appliance on heat sensitive surfaces during use.
• After use always switch the unit off and remove the plug from the power supply socket. Do
not pull on the wire to remove the plug from the power supply socket. Do not pull the plug
out of the power supply socket when your hands are wet.
• Always allow the unit to cool before putting it away and never wrap the cord around the unit.
• Check that the cord has not been damaged from time to time.
• Prevent the cord from coming into contact with the metal parts while these are still hot.
• Use the unit on dry hair.
• Do not use this unit on wigs that have synthetic hair.
• Do not use your unit if it is not working properly. Do not try to repair this electrical unit
yourself, rather contact an authorized technician.
• The elements used to pack the unit (plastic bags, cardboard box, etc.) must be kept out of
reach of children as they are a potential danger to them.
• This unit must only be used for the purposes for which it is expressly intended. Any other
use is to be considered improper and therefore dangerous. The manufacturer accepts no
responsibility for damage caused by improper or erroneous use.
• Do not use hair spray while the unit is running.
• Keep the plates clean and free of dust, hair spray, styling gel, etc.
• To avoid dangerous overheating, it is advisable to unwind the entire length of the cord.
OPERATING INSTRUCTIONS
1 Handgrip 7 Curling iron, Ø 38 mm
2 ON/OFF switch and temperature control 8 Spiralling iron
3 ON/OFF indicator 9 Triple iron/plate
4 Accessory release button 10 Cold end
5 Ion emission slot 11 Hair clip
6 Curling iron, Ø 25 mm 12 Stand
Switching the unit on
1. Insert the plug into the power socket.
2. To switch on the unit, slide the switch (2) to the required temperature setting.
3. Before using the appliance, leave the selected accessory heat up for at least 30 seconds.
4. To switch the unit off again, slide the switch (2) back to position 0.
Important: Never leave the appliance unattended when it is turned on.
Always use the stand (12) to hold the appliance when the fitted accessory is hot.
Changing the accessory
Only change the accessory with the appliance switched off and disconnected from the
electrical power supply. When changing accessories, only touch the plastic parts of the
appliance and the cold end (10) of the accessory. Metal parts may still be hot!
1. Press the accessory release button (4) and remove the accessory from the grip (1).
2. Fit the new accessory and push it firmly into the grip (1) until it clicks into place.
OPERATING TIPS
• This appliance has been designed to curl your hair, leaving it full of shine.
• Hair that has just been washed and dried can be styled better.
• The first few times you use this unit it is advisable to practice on small areas of your hair.
• The effect obtained depends on how thick and how long your hair is as well as curling time.
Start by using a curling time of 10-20 seconds.
• To make the appliance easier to use, hold the cold end (10) of the accessory with your
free hand.
• Use the various accessories supplied with the appliance as instructed below. If necessary,
repeat the various steps until you achieve the required effect.
• Let your hair cool completely before combing or brushing it.
5
00060508 int nov2013:Layout 1 27/11/2013 8.28 Pagina 5