2. Timeguard
  3. WF10COMIP

Timeguard WF10COMIP Operating instructions

  • Hello! I've reviewed the installation instructions for the TIMEGUARD WF10COMIP and WF10COM devices. This document describes how to install the enclosure box, ensuring correct mounting and wiring of the device. I'm ready to answer any questions you have about the product and its installation process.
  • What is the first step in the installation?
    What tool is needed to separate the faceplate from the back box?
    What is the required mounting position for the back plate?
    What is the purpose of the drain feature?
1. IMPORTANT. Switch off the electricity at the fuse box by removing the relevant
fuse or switching off the circuit breaker before proceeding with the installation.
WF10COMIP Enclosure Box Installation
2. Using a Philips screwdriver, separate the faceplate from the back box by
removing the four tapped screws located in each corner.
1
L L
N N
WF10COM
Supply
Load
WiFi: IEEE 802.11 b/g/n
Supply: 230V AC 50Hz
Max Load: 10A
400 Edgware Road,
London. NW2 6ND ON/OFF WiFi
3. Using the back plate as a template mark the position for the holes. Note the
back plate must be mounted in the horizontal position, following the ‘TOP’
marking inside the back plate. If the mounting position desired is uneven use
a sheet of marine ply as a base plate and fit the back box.
4. Drill the wall using a appropriate drill bit making sure not to infringe or
compromise any gas, water pipes or cables. Insert the rawl plugs into the
holes.
1
ISOLATE MAINS BEFORE SERVICING
400 Edgware Road,
London NW2 6ND.
EU - Theben AG. 72401
Haigerloch. Germany. WF10COMIP
1
230V
50Hz IP55 10A
WiFi: IEEE 802.11 b/g/n
2
5. Drill out the drain feature with a 5mm drill if required. Opening the drain hole
will reduce the IP rating of the product.
6. Secure the back box to the wall using suitable screws for the rawl plugs installed.
Ensure that the back box is correctly orientated following the ‘TOP’ marking
which is labelled inside.
7. Pass the 230V AC 50Hz supply and load cables through the cable glands, noting
the correct orientation of the supply and load positions. Secure the cables tightly
to their respective terminals. Ensure that all bare conductors are sleeved and that
the correct polarity is observed; see the WF10COM manual supplied for the
appropriate wiring method. Use the earth terminal to connect the incoming and
outgoing earth conductors for earth continuity.
8. Once the mains supply is connected to the correct terminals, mount the face
plate over the back box aligning the four screws from the face plate to the four
mounting holes on the back box. Tighten until secured.
9. For all other instructions relating to the WF10COM, including pairing etc, refer
back to the WF10COM manual supplied with this product or refer to
www.timeguard.com for a copy if misplaced or lost.
1
L L
N N
WF10COM
Supply
Load
WiFi: IEEE 802.11 b/g/n
Supply: 230V AC 50Hz
Max Load: 10A
400 Edgware Road,
London. NW2 6ND ON/OFF WiFi
67.058.692 (Issue 1)
T.W - October 2021
/