2. SMITH SYSTEM
  3. 179868

SMITH SYSTEM 179868 Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the Silhouette Student Desk models 01600, 01601, 01602, 01603, 01648, 01649, 01650, 01651, 01653, 01654, 01657, 01675, 01676 and 01677. The document details the steps for assembling the desk, including attaching the legs, cross brace and adjusting the desk height. I'm ready to answer your questions about the assembly process or any other information you might need.
  • What should I do if I have missing or damaged components?
    What tool is needed to fully tighten screws?
    Can I use power tools during assembly?
Assembly Instructions
Silhouette Student Desk
If you have damaged or missing components,
please contact customer service at 1-800-328-1061
Document #: 179868 REVISED: 06/2023
Model Numbers: 01600, 01601, 01602, 01603, 01648, 01649 01650, 01651, 01653, 01654, 01657,
01675, 01676, 01677
Hardware and Components
Document #: 179868 REVISED: 06/2023
Special Notes:
•Check that all components are accounted for and undamaged before assembling.
•Please assemble the product in a clean and dry area.
•You may need another person to help assemble the product. Team lifting may be
required.
•Clean the product with a mild cleaner and a damp cloth.
Assembly Instructions
Document #: 179868 REVISED: 06/2023
1. Place the tabletop on a clean
surface facedown, with seam
location furthest away from you.
NOTE: A screwdriver or drill with the appropriate extension can be used to fasten in
the screws on to the table.
2. Loosely attach Cross Brace to
T-Legs using M8x12MM Cap Screws.
3. Align the rear of the bracket to
be flush with the tabletop edge.
Once flush, fasten the end of the
bracket to the tabletop using a #10
Wood Screw. Repeat for both legs.
4. Align the front of the bracket to be flush
with the tabletop edge. Pull the front of the
leg inward and hold it in place. Fasten the
end of the bracket to the tabletop using a
#10 Wood Screw. Repeat for both legs.
Assembly Instructions
Document #: 179868 REVISED: 06/2023
5. Finish fastening the T-Legs to
the tabletop by driving a #10 Wood
Screw in the center hole on each leg
bracket.
NOTE: A screwdriver or drill with the appropriate extension can be used to fasten in
the screws on to the table.
6. Fully Tighten all (4) M8x12MM Cap
Screws using the provided Allen Wrench.
(Screws from step 2)
8. Flip the desk right-side-up. Product is
now ready for use.
7. Using the provided Allen Wrench,
partially extract the pre-installed 3/8”-16
Dog Nut Screws from the T-Legs and adjust
the T-Legs to the desired height. Pin the
desk at the desired height by retightening
the Dog Nut Screws.
/