INSTALLATION AND USE OF THE DA 224
INDEX
1.0 Overview
2.0 Power supply
3.0 Presettings
4.0 Installation
5.0 Accessories
6.0 Technical data
7.0 Note
Please read this manual carefully before installing the DA 224.
The manufacturers shall not be answerable for damage resulting from the
use, proper or otherwise, of their products.
Product data and specifications are subject to change without prior notice.
-
Input
Input impedance
Input level
CMRR
Output gain
Fixed gain
Output
Hum & noise
Size (WxDxH)
Weight
Safety
EMC
Mark
7.0 NOTE
consignee.
DA 224 DUAL 1x4 BAL. AUDIO DISTR. AMPLIFIER DA 224
2
ELPRO BROADCAST s.r.l.
Strada della Pronda 17 - TORINO (ITALY)
Tel. 0117071955 - FAX 011706210 7
1.0 OVERVIEW
Thank you for choosing this product. Check that the following items are
included in the packaging:
36
DA 224 DUAL 1x4 BAL. AUDIO DISTR. AMPLIFIER
ELPRO BROADCAST s.r.l.
Strada della Pronda 17 - TORINO (ITALY)
Tel. 0117071955 - FAX 011706210
− The AC adapter code ADM001
− This handbook
- The DA224 unit
The DA224 is a distributor/amplifier for stereo audio signals that is capable of
distributing a signal towards 4 destinations.
It can be used as an amplifier for low level incoming signals. In the case of
mono signals only, the DA224 is capable of amplifying two separate signals
with separate gain settings.
2.0 POWER SUPPLY
The DA224 unit must only be powered by means of the AC/AC adapter, code
ADM001, supplied.
ATTENTION
The use of any other adapter may damage the equipment.
There are no ratings or presettings inside the unit.
All operations must be performed by specialized personnel.
Insert the adapter in a 220-230 Vac/50Hz alternate voltage socket.
DA 224 DUAL 1x4 BAL. AUDIO DISTR. AMPLIFIER
4 5
ELPRO BROADCAST s.r.l.
Strada della Pronda 17 - TORINO (ITALY)
Tel. 0117071955 - FAX 011706210
3.0 PRESETTINGS
6 dip-switches that can be accessed from the base of the unit enable the gain
for the two channels to be selected separately.
1 R +24dB : In ON pos. channel R gain is +24dB
2 R +10dB : In ON pos. channel R gain is +10dB
3 R 0 dB : In ON pos. channel R gain is 0dB
4 L +24dB : In ON pos. channel L gain is +24dB
5 L +10dB : In ON pos. channel L gain is +10dB
6 L 0dB : In ON pos. channel L gain is 0dB
ATTENTION
Only one switch per channel may be set to ON
Factory settings of the unit are as follows:
1 R +24dB : In OFF pos.
2 R +10dB : In OFF pos.
3 R 0 dB : In ON pos.
4 L +24dB : In OFF pos.
5 L +10dB : In OFF pos.
6 L 0dB : In ON pos.
4 5
DA 224 DUAL 1x4 BAL. AUDIO DISTR. AMPLIFIER
ELPRO BROADCAST s.r.l.
Strada della Pronda 17 - TORINO (ITALY)
Tel. 0117071955 - FAX 011706210
4.0 INSTALLATION
Proceed as follows for standard installation with a stereo signal to be
distributed towards 4 destinations:
a) Check that all the units to be installed are turned off.
b) Connect the stereo source to the INL and INR terminals
c) Connect the destinations
d) Set the dip-switches on the base according to system requirements
e) Energize the DA224 and the other system units.
f) If necessary, adjust the output level of both channels by means of the
trimmers on the front rearl of the unit.
3
DA 224 DUAL 1x4 BAL. AUDIO DISTR. AMPLIFIER
6
ELPRO BROADCAST s.r.l.
Strada della Pronda 17 - TORINO (ITALY)
Tel. 0117071955 - FAX 011706210
−
−
ATTENTION
The ground terminal
(GND) is common to
channels L and R
ATTENTION
If the incoming signal is
unbalanced, connect the
hot pole to terminal "a"
and the cold pole to
terminal "b".
Then jumper "b" with
GND
ATTENTION
The DA224 input has a
high impedance level.
The inputs of several
DA224 units can be
paralleled
ATTENTION
The output terminal "a" is in phase
with the input terminal "a".
The output terminal "b" is phase
opposite with "a".
ATTENTION
If the destination is unbalanced,
connect terminal "a" and GND.
Leave terminal "b" clear or use it
for a different destination.
1 R +24dB : In OFF pos.
2 R +10dB : In OFF pos.
3 R 0 dB : In ON pos.
4 L +24dB : In OFF pos.
5 L +10dB : In OFF pos.
6 L 0dB : In ON pos.
5.0 ACCESSORIES
The following are supplied as part of the DA224 unit:
- Mains adapter code ADM001
6.0 TECHNICAL DATA (Each section)
Input :Differential, DC coupled (Internal H.P.filter)
Input impedance :44KΩ
Input level :+19 dBm Max
CMRR :80dB at 50Hz
72dB at 16KHz
Output gain :0 dB±6dB front panel adjustable
Fixed gain :0,+10,+24 dB jumper selectable
Output :4, electronically balanced
Frequency response : -0.5 dB from 7Hz to 90KHz
-3 dB at 150KHz with +20dB gain
Harmonic distortion :<0.05% from 20Hz to 20KHz at 19dBm
Hum & noise :-88 dB unweighted
Crosstalk (two sections) :50 dB at 16KHz
Main input (with AC adapter ADM 001) :230 Vac 50 Hz
Power consumption :5 VA
Size (WxDxH) :220 x 100 x 55 mm
Weight :0.6 Kg
Operating temp. range :0 ÷ 45°C
Safety :according to EN 60065
EMC :according to EN 55103-1 and EN 55103-2
Mark
7.0 NOTE
This product is guaranteed for 2 years from the date of purchase.
The guarantee does not cover damage to the product caused
by improper use or operations effected by third parties
For the duration of guarantee Elpro shall repair faulty units free of charge.
Faulty units must be sent with a standard waybill and CARRIAGE PAID to Elpro’s
Turin works.Repaired units shall be returned CARRIAGE FORWARD to the
consignee.
Faulty units that are no longer covered by guarantee shall be repaired by Elpro EX
WORKS Turin and the work shall be charged to the customer.
For any problems regarding installation of the DA224
call the Elpro hot line 011 705835
or send an E-mail to: elpr[email protected]
DA 224 DUAL 1x4 BAL. AUDIO DISTR. AMPLIFIER
2
ELPRO BROADCAST s.r.l.
Strada della Pronda 17 - TORINO (ITALY)
Tel. 0117071955 - FAX 011706210
7
INDEX OF ACCESSORIES INFOVIDEO LINE
Cod. ELPRO Description
− ADC 101MM Cable HDD 15 p. m./m. 1,5 mt.
− ADC 101 Cable HDD 15 p. m./f. 1,5 mt.
− ADC 105 Cable HDD 15 p. m./f. 5,0 mt.
− ADC 110 Cable HDD 15 p. m./f. 10,0 mt.
− ADC 120 Cable HDD 15 p. m./f. 20,0 mt.
− ADC 130 Cable HDD 15 p. m./f. 30,0 mt.
− ADC 201 Adapter cable HHD 15 p. m./5 BNC
− ADC 301 MAC Adapter cable DB 15 p. f./HHD 15 p. m.
− ADC 401 SUN Adapter cable 13W3 f./HHD 15 p. m.
− ADC 402 SUN Adapter cable 13W3 m./HHD 15 p. f.
− ADC 501 SGI Adapter cable 13W3 f./HHD 15 p. m.
− ADC 502 SGI Adapter cable 13W3 m./HHD 15 p. f.
− ADC 710 Cable for TCR 03 DB 15 p. m./f. 10mt.
− ADM 001 AC Adapter 230 Vac 50Hz 9V 500mA
− ADM 010 AC Adapter 230 Vac 50Hz 9V 1000mA
− ADP 010 Connector DB 15 p. m. with cover
− ADP 101 VGA Adapter m./m.
− ADP 102 VGA Adapter f./f.
− ADP 302 MAC Adapter plug DB 15 p. m./HHD 15 p. f.
− ADR 2U Rack adapter 2U
− ADR 3U Rack adapter 3U
− ADR 2U BLK Blank panel 2U
− ADR 3U BLK Blank panel 3U
− EP BOX1 Kit for wall mounting of EASYPATCH
− EP RACK1 Mounting on 19" of EASYPATCH
ELPRO BROADCAST s.r.l.
Strada della Pronda 17 - TORINO (ITALY)
Tel. 0117071955 - FAX 011706210 8 1
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Kramer RK-10MT User guide
-
GFW Turin Window Fabric Seat User manual
-
Fadini junior633-650 65 Instructions Manual
-
-
-
-
-
-
-