2. Dunlop
  3. WA44

Dunlop WA44 User manual

  • Hello, I've reviewed the user manual for the MXR Wylde Audio WA44 Overdrive. This manual provides details on how to set up the pedal, adjust the output volume, tone, and gain and it also describes the way of powering it. I'm ready to answer any questions you have about this device.
  • How do I turn the effect on?
    How do I adjust the effect volume?
    How do I get a brighter tone?
    How do I increase the overdrive intensity?
Wylde Audio Overdrive
Celebrate the 20th anniversary of the explosive
collaboration between Dunlop and Zakk Wylde with
the MXR Wylde Audio Overdrive. Custom built for
Zakk’s loud, tough, and relentless ris and leads, this
muscular stomp box will transform your amp into
a heavy, chunky crunch machine.
WA44
jimdunlop.com/wa44
®
WA44 | MXR® Wylde Audio Overdrive 2
1 FOOTSWITCH toggles eect on/bypass (red LED indicates on)
2 OUTPUT knob adjusts overall eect volume
3 TONE knob adjusts overdrive EQ
4 GAIN knob adjusts overdrive intensity
3
24
External Controls
1
WA44 | MXR® Wylde Audio Overdrive 3
Basic Operation
1. Run a cable from your guitar to the WA44’s INPUT jack
and run another cable from the WA44’s OUTPUT jack to your
amplier.
2. Start with all knobs at 12 o’clock. Turn the eect on by
depressing the footswitch.
3. Rotate OUTPUT knob clockwise to increase eect volume
or counterclockwise to decrease it.
4. Rotate TONE knob clockwise for a brighter tone or
counterclockwise for a warmer tone.
5. Rotate GAIN knob clockwise to increase overdrive
intensity or counterclockwise to decrease it.
The MXR® Wylde Audio Overdrive is powered by a single
9-volt battery (remove bottom plate to install), a 9-volt AC
adapter such as the Dunlop ECB003, or an MXR® Brick™
Series power supply.
Power Directions
WA44 | MXR® Wylde Audio Overdrive 4
Specications
Input Impedance 1 MΩ
Output Impedance 7.5 kΩ
Nominal Input -22 dBV
Noise Floor* -88 dBV
Bypass Hardwire
Current Draw 2.2 mA
Voltage Requirements 9 volts DC
* A-weighted
/