Metra 95-3016G User manual

Category
Car kits
Type
User manual
METRA. The World’s best kits.
metraonline.com
© COPYRIGHT 2015 METRA ELECTRONICS CORPORATION
REV. 6/23/2015 INST95-3016G
CAUTION: Metra recommends disconnecting the negative battery
terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your
local Dealership for more information. All accessories, switches,
climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling
the ignition. Also, do not remove the factory radio with the key
in the on position, or the vehicle running. It would be best to
remove the key from the ignition and then wait a few seconds
before removing the factory radio.
Installation instructions for part 95-3016G
• ISODoubleDINradioprovision
• Painted gunmetal gray
•A)Radiotrimpanel•B)Radiobrackets•C)(4)#8x3/8”Phillipspan-headscrews
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS(soldseparately)
WiringHarness:•GMOS-LAN-09•LC-GMRC-LAN-09•AX-LCD
AntennaAdapter:•40-EU55
•Cuttingtool•Panelremovaltool
•Phillipsscrewdriver•Socketwrench
TOOLS REQUIRED
A B
C
Dash Disassembly................................................. 2
Kit Preparation....................................................... 2
Kit Assembly
ISODoubleDINradioprovision............................. 3
Table of Contents
Chevy Colorado, GMC Canyon 2015-up
(Sub-dash modifications required)
95-3016G
95-3016G
2
Dash Disassembly
1. Unclipandremovethetrimpanel
surroundingtheradio/climate
controlpanel.(FigureA)
2. Remove(4)9/32”screwssecuring
theradio/climatecontrolpanel.
(FigureB)
3. Remove(2)9/32”screwssecuring
theCDplayerthenunplugand
removetheplayer.
4. Unclipandslideoutthefactory
tunermodulethenunplugand
removeit.
5. Unclipandremovetheclimate
controlsfromthefactory
trimpanel.
6. Unclipandremovetheclimate
controlventsfromthefactory
trimpanel.
Continue to kit preparation
Kit Preparation
1. Cutandremovethespecified
areasinthesubdash.(FigureA)
Continue to kit assembly
Removeshadedarea
(Figure A)
(Figure B) (Figure A)
95-3016G
3
Kit Assembly
(Figure A) (Figure B)
Double DIN radio provision
1. Attachtheradiobracketstothe
radiotrimpanelwith(4)ofthe
supplied#8x3/8”Phillipsscrews.
(FigureA)
2. Slidetheradiointothebrackettrim
panelassemblyandsecurewith
thescrewssuppliedwiththeradio.
(FigureB)
3. Cliptheclimatecontrolsintothe
radiotrimpanelassembly.
4. Cliptheclimatecontrolventsinto
theradiotrimpanelassembly.
5. Locatethefactorywiringharness
andantennapluginthedash.
Metrarecommendsusingthe
propermatingadaptersfromMetra
and/orAXXESS.
6. Reassemblethedashinthe
reverseorderofdisassembly.
REV. 6/23/2015 INST95-3016G
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
Installation instructions for part 95-3016G
METRA. The World’s best kits.
metraonline.com
© COPYRIGHT 2015 METRA ELECTRONICS CORPORATION
IMPORTANT
If you are having difficulties with the installation
of this product, please call our Tech Support line
at 1-800-253-TECH. Before doing so, look over
the instructions a second time, and make sure
the installation was performed exactly as the
instructions are stated. Please have the vehicle
apart and ready to perform troubleshooting
steps before calling.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Metra 95-3016G User manual

Category
Car kits
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI