Bully Dog 31304 '11-'15 Ford Super Duty Owner's manual

Type
Owner's manual
Questions about installation or product details? Contact our Tech Support team at 940-783-9914
Cap Locations
Part# 31304: Works On: Ford 6.7L Super Duty ’11- ’15
Custom A-Pillar Pod
Installation Instructions
A-Pillar Pod
POD
Adapter
WHAT’S INCLUDED:
Screw
Place at head screwdriver in the middle of each
side of the cap and open cap, taking care not to
damage stock A-pillar.
Using a 7mm socket with extension and ratchet;
unscrew the two bolts securing the stock A-pillar
where the caps were opened up. Loosen them all
the way and remove stock A-pillar.
Pull back weather stripping in the area
of the A-pillar and remove the side
panel of the dash by the driver door.
STEP 1:
STEP 2:
STEP 3:
Questions about installation or product details? Contact our Tech Support team at 940-783-9914
STEP 5:
STEP 6:
Install the custom gauge pod by rst aligning
the tab into the slot on dash. Guide custom
gauge pod so the screw hole lines up with the
stock screw hole. Secure using the supplied
screw, not the stock screw.
Secure the weather stripping, install the side
panel and the job is nished.
GT Head Unit
GT Custom Pod Adapter
Custom Gauge Pod
(To OBDII Adapter Plug)
Main Harness
Main Harness Plug
STEP 4:
If installing another tuner install the appropriate pod adapter at this time. LWTS+ requires part
# 30604 and GTX requires part # 30605, which is not included. Follow instructions on installing
the located on the inside of the packaging card. If you have stock speakers be sure to recon-
nect them at this time.
31304-99_v1.2
  • Page 1 1
  • Page 2 2

Bully Dog 31304 '11-'15 Ford Super Duty Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI