1
Wiremold / Legrand electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold / Legrand electrical
products may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
Walmart Checkout Light
Power Pole
INSTALLATION INSTRUCTIONS
Installation Instruction No.: INST030R1 – Updated February 2008
IMPORTANT: Please read all instructions
before beginning.
Step 2 Select the required position (A,B,C or D) as
shown. If installing sign on a 3 compartment
pole in position “B” or “D” See Step 2A
below, otherwise move on to Step 3.
Step 1 Remove and save the screws from the
cover and remove the cover.
Step 2A To install sign on a 3 compartment pole in
position “B” or “D” bend tabs as shown.
This will allow the mounting bracket to fit
the additional width of pole.
Step 3 Slide the checkout light onto the existing power
pole at the required height. (Be sure the light
receptacle is exposed) The pole will contact the
checkout light at the two points represented by
the two arrows.
B
A
C
D
Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
INST030R1
© Copyright 2008 Wiremold / Legrand All Rights Reserved
Step 4 Firmly hand tighten the two thumbscrews.
Plug the lampholder wiring harness into
the light receptacle.
Step 5 Install the number plate with appropriate number
in the housing.
Thumbscrews
Panel Tracks
Step 6 Slide the other number plate down into the
panel tracks on the cover.
NOTE: Access and lamp change in the future will be through
this slide up number plate.
Step 7 Place the universal-Trim plate around the
pole, inside the sign at the bottom.
Step 8 Reinstall the front cover using the
original screws.
NOTE: Use only the acrylic diffuser supplied with this light by
the manufacturer. There are no substitutions allowed.
/