Bullet Tools CK50-1110 Installation guide

Type
Installation guide

This manual is also suitable for

INSTALLATION GUIDE
1. Take the Bullet Tools knife handle and unscrew the screw.
2. Remove the screw and the two pieces of the handle.
3. Take your straight blade and line up the holes in the top of
the handle making sure that the sharp part of the blade is
on the same side of the finger notch in the handle.
4. Place the other half of the handle on top of the straight
blade that is in one half of the handle.
5. Take the screw and tightly screw it back into the same
whole it was removed from.
6. To learn how to safely sharpen the blade contact us at
208-772-0175
  • Page 1 1

Bullet Tools CK50-1110 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI