Bullet Tools CB00-1103 Installation guide

INSTALLATION GUIDE

1. Take the Bullet Tools knife handle and unscrew the screw.

2. Remove the screw and the two pieces of the handle.

3. Take your straight blade and line up the holes in the top of

the handle making sure that the sharp part of the blade is

on the same side of the finger notch in the handle.

4. Place the other half of the handle on top of the straight

blade that is in one half of the handle.

5. Take the screw and tightly screw it back into the same

whole it was removed from.

6. To learn how to safely sharpen the blade contact us at

208-772-0175

This manual is also suitable for

Download PDF