Noble House 1239 Operating instructions

Brand
Noble House
Model
1239
Type
Operating instructions

This manual is also suitable for

Club Chair
Caution :You must read this before you proceed
1 of 51 of 5
Label Picture Description QTY
A Chair 1
B Wooden Leg 4
Label Picture Description QTY
C Washer Rings 7 pcs
2 of 5
Before Beginning Assembly:
2 of 5
Step 1
Step 2
Position the chair on its back,as shown.
Unzip to open pouch and remove the 4 wooden legs, close the pouch.
3 of 5
Install leg into the chair by putting a Washer Ring (optional )on the threaded stem and
then insert the threaded stem into the threaded hole at each corner of the bottom of
the chair.
Tighten by turning leg clockwise.
Repeat the same Step to install the other three legs.
When assembling the Legs, the two BEVELLED Slant-Angled face of wooden leg
must be affixed to be inwards facing.
This is the same Position for both the FRONT and BACK pair for both LEFT and
RIGHT Legs - BEVELLED Slant Angled face of the wooden legs are inward facing.
3 of 5
Step 3
Make sure all parts are connected and locked into position.
Your chair is ready for use.
4 of 54 of 5
5 of 55 of 5
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Noble House 1239 Operating instructions

Brand
Noble House
Model
1239
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents