Phoenix Gold TI265PS User manual

Brand: Phoenix Gold

Model: TI265PS

Category: Loudspeakers

Type: User manual

TI2 PointSource

OWNER’S MANUAL

www.phoenixgold.com

Ti2 Pointsource Owner’s Manual

A few words ABOUT Design

Specifications

Ti265ps Ti257ps Ti269ps

RMS Power Handling 100 watts 100 watts 100 watts

PEAK Power Handling 200 watts 200 watts 200 watts

Nominal Impedance 4 ohms 4 ohms 4 ohms

Sensitivity 91dB 91dB 92dB

Mounting Depth 65mm -

2.55 inches

59mm -

2.4 inches

78mm -

3.1 inches

Mounting Diameter 145mm -

5.7 inches

127mm x 182mm -

5 x 7.2 inches

151mm x 221mm

6 x 8.7 inches

Thank you for purchasing the Phoenix Gold Ti2 Pointsource speaker system. It features a 20mm pure silk dome

tweeter that is mounted in a pointsource conguration. The 6.5” midrange has a unique dual roll surround

that eliminates unwanted resonances, acoustical artifacts and dampens mechanical vibrations. The tweeter

and midrange has been specically engineered with complex FEA analysis that perfectly optimizes the motor

structures. In addition, the passive crossovers are computer modeled and then real world (in car tested and

further tweaked) tuned to provide a seamless transition from the midrange to tweeter. Whether you are looking

to upgrade tired factory speakers or desire studio grade performance the Ti2 pointsource systems are the perfect

solution.

FEATURES:

• 20mm Silk Dome Tweeter

• Poly Treated Paper Cone

• Smooth Termination Dual Roll Rubber Surround

• Powder Coated Stamped Steel Basket

• 24dB External Audiophile Crossover

• High Temperature CAE/CAD Motor Structure

www.phoenixgold.com

Ti2 Pointsource Owner’s Manual

Crossover wiring

INSTALLATION:

- The provided external passive crossovers MUST be used with the Ti2 Pointsource speakers. Speaker damage

WILL occur if the external crossovers are not used.

- Installation is simple just follow the clearly marked labels on the wiring and speaker terminals. The wiring

connections are also marked on the internal PCB which is accessible by removing the crossover housing’s top

cover.

- Each speaker has two seperate (and clearly labeled) terminals: one for the tweeter and one for the woofer. Both

terminals must be used and connected to the correct wires on the passive crossover.

- IMPORTANT: USE THE PRE-TERMINATED SPADE TERMINALS FOR EASY INSTALLATION. DO NOT CUT THEM OFF!

The crossover wires are pre-terminated with the correct size spade terminals that match the correct size terminal

on the speaker. This makes installation much faster/easier, and also makes it impossible to mistakenly wire the

woofer wires from the crossover to the tweeter terminal on the speaker.

- Double check all the wiring connections before turning the system on. Most importantly double check the

woofer wires from the crossover are NOT wired to the tweeter terminal of the speaker. The tweeter will be

damaged if this occurs.

POINTSOURCE

CROSSOVER

To Amplifier

or Headunit

To Tweeter

To Woofer

T+ T-

W+ W-

+ -

www.phoenixgold.com

Phoenix Gold

A Division of AAMP of America™

13190 56th Court

Clearwater, Florida 33760

P: 866-788-4237

[email protected]

www.phoenixgold.com

Designed and Engineered in the USA

LIMITED WARRANTY

Phoenix Gold warrants this product to be free of defects in materials and workmanship for a period of one (1) year from the original date of purchase. This

warranty is not transferable and applies only to the original purchaser from an authorized Phoenix Gold dealer in the United States of America only. Should

service be necessary under this warranty for any reason due to manufacturing defect or malfunction, Phoenix Gold will (at its discretion), repair or replace the

defective product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident, misuse, abuse,

product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not

cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear

and tear is not covered under warranty.

INTERNATIONAL WARRANTIES

Products purchased outside the United States of America are covered only by that country’s Authorized Phoenix Gold reseller and not by Phoenix Gold.

Consumers needing service or warranty information for these products must contact that country’s reseller for information.