Cable set

KUFATEC Cable set User manual

  • Hello! I have reviewed the Installation Instructions for the Side Assist system. This document outlines the steps required for installation, including cable routing, component placement, sensor assembly, and system coding. I'm ready to answer your questions about the installation process or any other aspects of the system.
  • What is the purpose of the document?
    What is shown in Figure 3?
    What is covered in the document?
Installation Instructions
Side Assist
v1.1 (09.12.2019)
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected]e 1
Contents
1 Liability Exclusion 3
2 Copyright 4
3 General notes 4
4 Safety Instructions 5
5 Requirements for the intended use 5
6 How to connect a cable to another 6
7 Note Cable Inscription/Color 7
8 Assembly Instructions 8
9 Assembly Note 9
10 Disassembly rear side covering passenger’s side 10
11 Disassembly rear bumper 14
12 Disassembly front covering passenger’s side 16
13 Disassembly door covering 17
14 Disassembly mirror 19
15 Assembly sensors rear bumper 20
16 Cable routing from the back to the front 21
17 Cable routing from the passenger’s side to the driver’s side 22
18 Modification mirror until model year 2019 23
19 Modification mirror from model year 2020 25
20 Connection CAN High + CAN Low / Power supply 27
21 Cable connection door coupling connector interior 29
22 Cable routing door 30
23 Coding with Coding Interface 31
24 Coding Interface 31
25 Bus rest 31
26 Connection/Troubleshooting cable set 33
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected]e 2
8 Assembly Instructions
The following illustration shows the cable routing as well as the position of the individual components.
1
2
3
1
1
3
3
2
Figure 3: Vehicle overview
1 Sensor
2 Connection cable set
3 Warning light
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected]e 8
/