RECOMMENDED TOOLS
OUTILS RECOMMANDÉS
Attention:
for easy installation, you will need:
1.To read all the installation instruction completely before
beginning.
2.To read all the warning, attention and maitenance
information.
3.To purchase the proper supply lines.
The tools might be applied to the following places:
Step 4 Cleaning and care
Daily cleaning and care are required in order to keep the product shining and
properly working.
1
2
3
4
Clean it with water and dry it with soft cloth.
Clean the product with gentle liquid or glass cleaner.
Don't use acid cleaner.
Don't clean with abrasive material, abrasive paper or knife.
Step 5 Parts list
Channel Locks
Adjustable Wrench
Silicone
Allen key
WARNING:
Please keep the
tool for future
use!
Goggles
Teflon tape
Screwdriver
ROMAN TUB FAUCET
The product is CUPC, ADA certified.
Original certification model code: 2B469MV2
104224-BTF-PC
PART NAMENO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Allen screw
Allen screw
Nut
Aerator
Aerator base
O-ring
O-ring
Converter pipe
O-ring
Rubber washer
Clamp
Nut
Lift rod
Spring
Glochidion lanceolarium
Diverter
Water valve
Valve
Washer
Spout connector
Cartridge
ShowerConverter pipe
Screw index
Pull-out hose
Flexible hose
Nut
Washer
Shower holder
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
3744
43
42
41
40
39
38
Lift rod
Handle flange
Clamp
Gasket assembly
Handwheel
Rubber washer
Cartridge locknut
Ring
O-ring
Adapter
Diverter cover
Body
Screw
Water way
Clamp spring
2
Step 2 Checking and testing
Check all connections at arrows for leaks,
re-tighten it if necessary.
Step 1 Faucet installation
1
2
Step 3 Maintenance
If faucet leaks from the handle or drips from spout, please replace cartridge following the following steps:
1
2 3
3
BUT DON'T OVERTIGHTEN
4
Hot water
Cold water
O-ring
5
A. B. C.
Connect to water supply lines with either:
(A)3/8” O.D. Copper tubing (ball nose risers with the
coupling nuts) or;
(B)3/8” Copper tubing (no ball) with supplied tube head
interior connector or;
(C)IPS faucet connectors(½”).
Disassemble the screw② with Allen key③ ,
take out the handle① and base④.
Unscrew the old cartridge② with Adjustable
Wrench①, then take it out .
Place a new cartridge in the cartridge seat,
then screw the base and assemble the
handle by securing the screws.Repeat
the above steps for the other cartridge if
necessory.
1
2
3
4
1
2
Disassemble the parts as photo. Position the parts as shown and secure each parts with
tools respectively.
Position the hand shower and secure it with fixing kit.
Caution: DON'T FORGET THE O-RING BETWEEN THE
HAND SHOWER AND HOSE.
Connect the parts with supply lines as shown and tighten
them with wrench.
Warning:
The water supply lines are not included, please purchase
them in plumbshop.
/