Page is loading ...
ASME A112.18.1/CSA B125.1
The tools might be applied to the following places:
SINGLE HANDLE LAVATORY FAUCET
PART NAMENO.
1
2
3
4
5
6
Handle
7
8
9
Index
10
Screw
11
12
13
14
15
16
17
18
Clamp
Lock nut
Screw
Trim cap
O-ring
Cartridge lock nut
Body
Aerator core
Copper tube
Copper tube
Allen key
Cartridge
Washer
Aerator collar
1
4
5
6
7
8
9
10
12
13
14
15
11
16
17
18
2
3
Base
Channel Locks
Adjustable Wrench
RECOMMENDED TOOLS
Attention:
for easy installation, you will need:
1.To read all the installation instruction completely before
beginning.
2.To read all the warning, attention and maitenance
information.
3.To purchase the proper supply lines.
Allen key
WARNING:
Please keep the
tool for future
use!
Goggles
Teflon tape
Basin wrench
L-AZ030
Step 4 Parts list
INSTALLATION MANUAL
1-844-44-ANZZI or visit www.ANZZI.com
Per fection is our Tradition
MT
Step 1 Faucet installation
Hot
Cold
2
1
3
1.
2.Secure the faucet with fixing kit and tighten the lock nut with allen wrench.
Position the faucet with o-ring on the installation surface.
3.
wrench. DON'T OVER TIGHTEN! Caution: make sure connect the hot and cold flexible hose to supply valves
correctly.
Connect the flexible hoses to water supply valve (not included) and copper tubes, and tighten it with adjustable
Warning:
The supply valves are not included, please purchase them in plumb shop.
Step 2 Checking and testing
Step 3 Cleaning and care
Daily cleaning and care are required in order to keep the product shining and
properly working.
1
2
3
4
Clean it with water and dry it with soft cloth.
Clean the product with gentle liquid or glass cleaner.
Don't use acid cleaner.
Don't clean with abrasive material, abrasive paper or knife.
2
1
1.Remove the aerator by . Turn the faucet handle all the way on, turn on hot and cold water supply and flush water
lines for one minute. Reinstall aerator by hand.
2.Check all connections at arrows for leaks, re-tighten it if necessary. BUT DON'T OVERTIGHTEN!
hand
/