Eave Vent Installation
Steps:
1. NOTE: Any eave vent that uses a damper to close off the opening
must be installed in a horizontal level position in order for the damper to
close properly.
2. Determine the proper location for installation. Trace the outline of the
duct onto the exterior soffit. Drill a starter hole in the soffit, if using a hole
saw attachment then drill in the center of the traced hole. If using a jig
saw then drill the starting hole on the outside edge of the traced line.
Cut the hole so it is slightly larger than the duct, if you cut along the
outside of the traced line this will give you a nice snug fit.
4. Connect the tailpiece to the existing exhaust duct with appropriate
clamp and UL foil tape (not provided).
6. Install the tailpiece into the cutout hole while positioning the vent in
the direction you desire.
7. Attach the eave vent to the soffit with 4 wood screws in the holes
provided (screws not provided).
/
