Kichler Lighting 10198BK User manual

Type
User manual
INSTALLATION INSTRUCTIONS
10198BK/WH
NOTE: This dimmer cannot be used with 10192BK60 or BK96 power supplies.
NOTE: The load on the dimmer cannot exceed 48W. Exceeding 48W may result in damage to the dimmer and tape system.
WARNING:
 •Thedimmershouldalwaysbeinstalledonthe24V,lowoutputsideofthepowersupply.
 • Donotconnectto120V,ordamagetothedimmerandtapesystemmayoccur.
 • Foruseindrylocationsonly.
CONNECTING:
1) The10198in-linedimmermustbeconnecteddirectlytothe24VoutputDC2.1jackfromthepowersupply.Connectthemale
  DC2.1jackfrompowersupplytothefemaleconnectoronthedimmer.
2) ConnectthemaleDC2.1jackofdimmertothefemaleDC2.1jackonthetapelightpowersupplylead.
OPERATING:
1) Toturnlightson,twistthedialonthedimmerclockwiseuntilthelightreachesthedesiredlightlevel.
2) Toturnlightsoffordimdown,turnthedialonthedimmercounterclockwiseuntilthelightreachesthedesiredlightlevelor 
  youreachthefulloffpositionwhichisindicatedbya“click”.
ON
OFF
POWER
SUPPLY
DC 24V
DateIssued:12/7/12 IS-10198-CB
www.kichler.com
INSTRUCTIONS
For Assembling and Installing Fixtures in Canada
Pour L’assemblage et L’installation Au Canada
INSTRUCTIONS D’INSTALLATION
10198BK/WH
REMARQUE :Cegradateurnepeutpasêtreutiliséavecdesalimentations10192BK60ouBK96.
REMARQUE :Lachargedugradateurnepeutpasdépasserles48W.Toutevaleursupérieureà48Wpeutentraînerdesdom-
mages au système gradateur et guirlande.
AVERTISSEMENT :
• Legradateurdoittoujoursêtreinstallésurlecôtédesortiebasse,24Vdel’alimentation.
• Nepasconnecterà120Vsousrisqued’endommagerlesystèmegradateuretguirlande.
• Àutiliseruniquementdansdesendroitssecs.
CONNEXION :
1) Legradateurenligne10198doitêtreconnectédirectementàlapriseDC2.1desortie24Vdel’alimentation.Connecterla
  cheDC2.1mâledel’alimentationàlaprisefemellesurlegradateur.
2) ConnecterlacheDC2.1mâledugradateuràlapriseDC2.1femellesurleconducteurd’alimentationdelaguirlande.
FONCTIONNEMENT :
1) Pourallumer,tournerlecadransurlegradateurdanslesenshorairejusqu’àcequel’éclairageatteigneleniveaudeluminosité
  souhaité.
2) Pouréteindreouassombrir,tournerlecadrandanslesensanti-horairejusqu’àcequel’éclairageatteignedeniveausouhaité
  ouquel’onentendeun«clique»signalantlapositionmaximum.
ALLUMÉ
ÉTEINT
ALIMENTATION
DC 24V
  • Page 1 1

Kichler Lighting 10198BK User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages