Chromalox TW-TC-35 Installation guide

The TW-TC-35 Thermocube is a device which, when plugged into

a standard 120V AC electrical outlet, will automatically turn power on

and off to any device plugged into it. The Thermocube will automat-

ically turn on power when air temperature reaches approximately 35˚F

(2˚C) and will turn off the power when the temperature exceeds

approximately 45˚F (7˚C).

Maximum rating: 1800 watts, 15 amps, 120V AC.

For use with Thermwire Plug, Pre-terminated Heating Cable

assemblies. Circuits must be GFCI protected.

Plug TW-TC-35 Thermocube into GFCI Protected Circuit.

Before use and monthly thereafter, use a circuit tester to check that

the Thermocube is function for present condition: power off if tem-

perature is above 45˚F (7˚C) or power on if temperature is below 35˚F

(2˚C).

Plug pre-determined heating cable into thermocube.

Disconnect heating cable during summer months or extended peri-

ods when temperatures are not expected to be below 35˚F (2˚C).

PJ492

161-511931-003

JULY, 2004

(Supersedes PJ478-1)

TW-TC-35 Thermocube

GENERAL

INSTALLATION

1347 HEIL QUAKER BLVD., LAVERGNE, TN 37086

Phone: (615) 793-3900 www.chromalox.com

Limited Warranty:

Please refer to the Chromalox limited warranty applicable to this product at

http://www.chromalox.com/customer-service/policies/termsofsale.aspx.