TLD HB (0.8:1) Lens Kit
Installation Manual
R9842040
R5976662/01
22/12/2004
Barco nv Presentations
Noordlaan 5, 8520 Kuurne
Phone: +32 56.36.82.11
Fax: +32 56.35.86.51
E-mail: [email protected]
Visit us at the web: www.barco.com
Barco nv Events
Noord
laan 5, B-8520 Kuurne
Phone: +32 56.36.89.70
Fax: +32 56.36.88.24
E-mail:
Visit us at the web: www.barco.com
PrintedinBelgium
Copyright ©
All rights reserved. No part of this document may be copied, reproduced or translated. It shall not otherwise be recorded, transmitted or
stored in a retrieval system without the prior written consent of Barco.
Changes
Barco provides this manual ’as is’ without warranty of any kind, either expressed or implied, including but not limited to the implied war-
ranties or merchantability and fitness for a particular purpose. Barco may make improvements and/or changes to the product(s) and/or the
program(s) described in this publication at any time without notice.
This publication could contain technical inaccuracies or typographical errors. Changes are periodically made to the information in this
publication; these changes are incorporated in new editions of this publication.
Trademarks
Brand and product names mentioned in this manual may be trademarks, registered trademarks or copyrights of their respecti
ve holders.
All brand and product names mentioned in this manual serve as comments or examples and are not to be understood as advertising for
the products or their manufactures.
Table of contents
TABLE OF CONTENTS
1. TLD HB(0.8:1)LensKit ........................................................................................... 3
1.1 KitContents .......................................................................................................................... 3
1.2 Removingtheinstalledlens.......................................................................................................... 3
1.3 Installingthenewlens ............................................................................................................... 4
1.4 Focusingthelens .................................................................................................................... 5
1.5 Lens Formulas........................................................................................................................ 6
1.6 Cleaning the lens..................................................................................................................... 6
Index...................................................................................................................... 9
R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004 1
Table of contents
2 R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004
1. TLD HB (0.8:1) Lens Kit
1. TLD HB (0.8:1) LENS KIT
1.1 Kit Contents
Kit Contents
Contents
• TLD HB (0.8:1) Lens.
• Installation Manual.
• Toraysee
TM
Cloth.
1.2 Removing the installed lens
What has to be done?
Removing the installed lens on the SLM series projector.
Necessary Tools
No tools necessary.
WARNING: Risk of personal injury. Instructions for lens installation must be followed t
horoughly.
How to remove the installed lens?
To remove the lens, follow the next procedure:
1. Support the lens with one hand. (image 1-1)
2. Move the handle of the lens anchor system to the left. (image 1-2)
3. Take the lens unit out of the lens block. (image 1-3)
Image 1-1
Support the lens with one hand
R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004 3
1. TLD HB (0.8:1) Lens Kit
Image 1-2
Move the handle of the lens anchor system to the left
Image 1-3
Take the lens out of the lens block
1.3 Installing the new lens
What has to be done?
This new lens has to be installed on the SLM series projector.
Necessary Tools
No tools necessary.
WARNING: Risk of personal injury. Instructions for lens installation must be followed thoroughly.
How to install the new lens?
1. Take the lens assembly out of is packing material and remove the lens caps on both sides.
2. Move the handle (A) of the lens anchor system to the right. (image 1-4)
4
R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004
1. TLD HB (0.8:1) Lens Kit
3. Push the lens in the lens block gap horizontally, until the lens clicks in lens anchor system.
Caution: For a table mounted projector, hold the projector when pushing the lens into the lens block to avoid sliding off from
the table.
Image 1-4
Lens installation
1.4 Focusing the lens
How to focus the lens?
To focus the lens, follow the next procedure:
1. Rotate the lens barrel (limited range!) for picture focusing. (image 1-5)
Image 1-5
Rotate the lens barrel for picture focusing
R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004 5
1. TLD HB (0.8:1) Lens Kit
1.5 Lens Formulas
Lens Formulas
PD
SW = Screen Height (Image Height)
PD = Projector Distance, distance between screen and projector
Projector
Screen
Image 1-6
To calculate the distance between the projector front side and the screen (PD) for a given screen width (SW), use the following
formula:
SLM Projector Formula (in meter) Formula ( in inches)
SLM G5 PD=0.85xSW+0.05 PD=0.85xSW+1.97
SLM G8 PD=0.85xSW+0.05 PD=0.85xSW+1.97
SLM G10 PD=0.85xSW+0.05 PD=0.85xSW+1.97
SLM R6 PD=0.84xSW+0.05 PD=0.84xSW+1.97
SLM R8 PD=0.84xSW+0.05 PD=0.84xSW+1.97
SLM R10 PD=0.84xSW+0.05 PD=0.84xSW+1.97
SLM R12+ PD=0.77xSW+0.05 PD=0.77xSW+1.97
RLM Projector
Formula (Metric) Formula (Inch)
RLM G5 (*) PD=1.06xSW+0.07 PD=1.06xSW+2.76
RLM G5+ (*) PD=1.06xSW+0.07 PD=1.06xSW+2.76
RLM H5 (*) PD=0.84xSW+0.07 PD=0.84xSW+2.76
RLM R6+
PD=0.77xSW+0.07 PD=0.77xSW+2.76
(*) Optical adapter R9832
650 is required
1.6 Cleaning the lens
To minimize the possibility of damaging the optical coating or scratching exposed lens surface, we have de-
veloped recommenda
tions for cleaning th e lens. FIRST, we recommend you try to remove any material f rom
the lens b y blowing it off with clean , dry deionized air. DO NOT u s e any liquid to clean the lenses.
Necessary tools
Toraysee
TM
cloth (d
elivered together with the lens kit). Order number : R379058.
How to clean the le
ns ?
Proceed as follow :
1. Always wipe lenses w
ith a CLEAN Toraysee
TM
cloth.
2. Always wipe lenses in a single direction.
Warning: Do not wipe back and forwards across the lens surface a s this tends to grind dirt into the coating.
6
R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004
1. TLD HB (0.8:1) Lens Kit
3. Do not leave cleaning cloth in either an open room or lab coat pocket, as doing so can contaminate the cloth.
4. If smears occur when cleaning lenses, replace the cloth. Smears are the first indication of a dirty cloth.
WARNING: Do not u se fabric softener when washing the cleaning cloth or softener sheets when drying the
cloth.
Do not use liquid c leaners on the cloth as doing so w ill contaminate the cloth.
CAUTION: Other lenses can also be cleaned safely with this Toraysee
TM
cloth.
R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004 7
1. TLD HB (0.8:1) Lens Kit
8 R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004
Index
10 R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004
Revision Sheet
To:
Barco nv Events/Documentation
Noordlaan 5, B-8520 Kuurne
Phone: +32 56.36.89.70, Fax: +32 56.36.88.24
From:
Date:
Please correct the following points in this documentation (R5976662/01):
page
wrong
correct
R5976662 TLD HB (0.8:1) LENS KIT 22/12/2004
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
Barco High Brightness TLD (0.8) User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Barco TLD (0.8) User manual
-
-
-
-
Barco RLM-W6 User manual
-
-
-
-
Barco RLM-W14 User guide
-
Barco RLM R6+ Performer User manual