Page 1
P0906186 Issue 02 Compact ICS 4.1 Programming Record
All defaults (for the Square template) are shown in bold and underlined text.
Copying set programming
You can use COPY to copy programming from one telephone to another set, a range of sets or all the sets. Depending on where
the display button is pressed, you will copy either all the programming for a telephone or only the programming found under
one of the individual sub-headings.
For general set copying, you can choose what part of the programming will be used. The choices are:
î‚• SYSTEM
î‚– the system administration programming (system data) of a set
î‚• SYSTEM+USER
î‚– the system administration programming PLUS the programming for a particular set (user data)
Customer/Company Supplier
Address Customer service representative
Telephone
Telephone
Billing number Installer
System coordinator Installation date
System Data which will be copied
Line access
Line assignment
Answer DNs (unless Answer button DN is same as set being copied to)
Line pool access
Prime line designation
Number of intercom keys
Outgoing line identification (OLI)
Restrictions
Set restrictions
Set Lock
Allow Last Number Redial
Allow Saved Number Redial
Allow Link
Line/set restrictions
Capabilities
Allow Redirect
Call Forward No Answer (DN or Route + destination + delay)
Call Forward Busy (DN or Route + destination)
Priority Calling
Paging
Redirect Ring
Auxiliary Ringer
DND on Busy
Hotline
Handsfree Answerback
Handsfree Setting
Direct-dial (which set is reached by
the D-Dial digit)
Pickup Group
Paging Zone
SLR redirection
ATA settings (except Use ringback
setting)
Telco Features
1stdisplay
Caller ID set (
Auto call info
)
Call log set (
Logging set
)
System data which will NOT be copied:
Line access
Private line appearances
Capabilities
Set Name
Use ringback setting under ATA settings
(for I-ATA only)
Telco features
Log password
Log space
CAP assignment
Direct-dial set designation
ExtraDial set designation
Service mode ringing set designation
Prime set designation for a line
Hunt group appearances
User data which will be copied:
Language choice
Ring type
Calls log options (
Auto logging)
Display contrast
Dialing options (automatic, predial,
standard)
User data which will be copied if
destination set type is the same as the
source set type:
External autodial button assignments
Internal autodial button assignments
Programmable button assignments
User data which will NOT be copied:
CAP module memory button assignments
Ring volume
User speed dial entries