FLEXCO Skirt Wear Liner Kit Operating instructions

Brand
FLEXCO
Model
Skirt Wear Liner Kit
Type
Operating instructions
Skirt Wear Liner Kit Instructions
Mounting Rail
Wear Plate
Clamp Bar RMC1 Clamp Kit
Tools Needed:
– Welder
– Tape Measure
– Level
– Paint Pen or Soap Stone
– Hammer/mallet
– 3/4" (19mm) Socket
PHYSICALLY LOCK OUT AND TAG THE CONVEYOR AT THE POWER SOURCE
BEFORE YOU BEGIN SKIRT CLAMP INSTALLATION.
Determine the correct position for the
mounting rail. Measure from the belt’s
surface up the skirt board and make
a mark at 9" (229mm) for the AR400
Liner or a mark at 9-3/4" (248mm) for
the Polyurethane Canoe Liner (Fig 1a).
Repeat this several times down the skirt
board and draw a line connecting the
marks (Fig 1b).
Mounting
rail height
measurment
Fig. 1a Fig. 1b
Mounting Rail Height
in. mm
AR400 Liner 9" 229 mm
Polyurethane Canoe Liner 9-3/4" 248 mm
Fig. 2
Weld the mounting rail in place using the line made in step 1 as a reference for
the bottom of the mounting rail plate.
Position the skirt material (not included) between
the 1" x 1" angle and the skirt board. e skirt rubber
should be positioned to the top of the belt. When in place,
lock the clamps by hammering the wedges on the clamp
pins tight (Fig. 5).
NOTE: Best practice is to lock the wedges horizontally
and in the direction of the belt travel. Ensure the ability to
unlock/loosen for service.
Fig. 3
Assemble the wear liner to the mounting rail. Hand thread the serrated nuts
onto the welded studs to temporarily hold the wear liner.
Fig. 4bFig. 4a
Fig. 5
Space the wear liner from the belt
1/8" to 3/8" (3 to 9mm) for the AR400
Liner and lightly touching the belt
for the Polyurethane Canoe Liner.
Tighten hardware to secure liner to the
mounting rail.
Gap to Belt
in. mm
AR400 Liner 1/8" to 3/8" 3 to 9 mm
Polyurethane Canoe Liner Lightly Touch Belt
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 • USA
Tel: (630) 971-0150 • Fax: (630) 971-1180 • E-mail: info@flexco.com
Visit www.flexco.com for other Flexco locations and products.
©2021 Flexible Steel Lacing Company. 08/31/21. For reorder: X6488
Tighten
Hardware Tighten
Hardware
1/8" to 3/8"
(3 to 8 mm)
Lightly
touching
belt
Belt Direction
Hammer wedges
in belt direction
  • Page 1 1
  • Page 2 2

FLEXCO Skirt Wear Liner Kit Operating instructions

Brand
FLEXCO
Model
Skirt Wear Liner Kit
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents