2. Titan Controls
  3. Zephyr 2

Titan Controls Zephyr 2 Operating instructions

  • Hello! I've reviewed the user guide for the Zephyr 2 High Temperature Shutoff Thermostat. This document outlines the installation and operation of the device, including setting high temperature limits, start delays, and optional cooldown settings. I'm ready to answer any questions you may have about using this device.
  • What does the 'Hold Restart' function do?
    How do I set the 'High Temp' and 'start delay' values?
    What is the default cooldown setting?
120Volts/15Amps/60Hz
High Temperature Shutoff with Delay
Zephyr2
B
Notes: This unit has been set to perform 10°F cooldown.
For 5° cooldown, refer to Optional settings.
Zephyr™
2
High Temperature Shut Off Thermostat
Easy Guide
VANCOUVER, WASHINGTON U.S.A.
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Step 2
Plug into 120VAC outlet
Connect the relay trigger cord set from lighting
controller into the front panel outlet
Note: If Zephyr 2 is plugged into a 24h timer, deduct start delay
from timer start program (start time).
Installation is now complete
Step 1
Set ‘High Temp’ and
‘start delay’ values
INSTRUCTIONS – REV. C
OPTIONAL SETTINGS
B
C
Change to 5°F cool down
A. Set both values to maximum
B. Plug in, then set both values to minimum within 5 seconds
C. Output light turns on or off according to actual setting
D. Follow instructions as shown in Step 1 & 2
Change to 10° cool down
A. Set both values to minimum
B. Plug in, then set both values to maximum within 5 seconds
C. Output light turns on or off according to actual setting
D. Follow instructions as shown in Step 1 & 2
120
Volts/15
Amps/60Hz
High
Temperature
Shutoff
with
Delay
Zephyr
2
120
Volts/15
Amps/60Hz
High
Temperature
Shutoff
with
Delay
Zephyr
2
High
temp
Sensor
Start
delay
HOLD RESTART
After Shut-OFF, the
unit will not restart
when knob is set
to HOLD RESTART.
120Volts/15Amps/60Hz
HighTemperatureShutoffwithDelay
Zephyr 2
120Volts/15Amps/60Hz
HighTemperatureShutoffwithDelay
Zephyr 2
120Volts/15Amps/60Hz
HighTemperatureShutoffwithDelay
Zephyr 2
120
Volts/15
Amps/60Hz
HighTemperature Shutoff with Delay
Zephyr2
Helios 4
240 Volt
sunlightsupply.com
120Volts/15Amps/60Hz
High Temperature Shutoff with Delay
Zephyr2
A
120Volts/15Amps/60Hz
High Temperature Shutoff with Delay
Zephyr2
B
C
120Volts/15Amps/60Hz
High Temperature Shutoff with Delay
Zephyr2
A
Notas: Esta unidad ha sido configurada para realizar la
función de enfriamiento a 10 °F. Para obtener información
sobre el enfriamiento a 5 °F, consulte la sección de
Configuraciones opcionales.
Zephyr™
2
Termostato de apagado a temperatura alta
Guía sencilla
VANCOUVER, WASHINGTON U.S.A.
www.titancontrols.net
Para obtener asistencia técnica, llámenos al
1-888-80-Titan o al 1-888-808-4826.
Paso 2
Enchufe a un tomacorriente de 120 VAC
Conecte el conjunto de cables del activador de relés del
controlador de iluminación al tomacorriente del panel delantero
Nota: Si el Zephyr 2 se enchufa en un temporizador de 24 horas,
reste el retardo de inicio del programa de inicio de temporizador
(hora de inicio).
La instalación se ha completado
Paso 1
Fije los valores de
“Temp. alta” y de
retardo de inicio
INSTRUCCIONES - REV. C
CONFIGURACIONES OPCIONALES
Cambio a enfriamiento a 5 °F
A. Fije ambos valores al máximo
B. Enchufe, luego je ambos valores al mínimo en
los 5 segundos siguientes
C. La luz de salida se enciende o se paga conforme a “
la conguración real
D. Siga las instrucciones descritas en el Paso 1 y 2
Cambio a enfriamiento a 10 °F
A. Fije ambos valores al mínimo
B. Enchufe, luego je ambos valores al máximo en
los 5 segundos siguientes
C. La luz de salida se enciende o se paga conforme a
la conguración real
D. Siga las instrucciones descritas en el Paso 1 y 2
120
Volts/15
Amps/60Hz
High
Temperature
Shutoff
with
Delay
Zephyr
2
120
Volts/15
Amps/60Hz
High
Temperature
Shutoff
with
Delay
Zephyr
2
Temp.
alta
Sensor
Retardo
de inicio
RETENER
REINICIO
Después de
apagarse, la unidad
no se reiniciará
cuando la perilla
se encuentra en
RETENER REINICIO.
120Volts/15Amps/60Hz
HighTemperatureShutoffwithDelay
Zephyr 2
120Volts/15Amps/60Hz
HighTemperatureShutoffwithDelay
Zephyr 2
120Volts/15Amps/60Hz
HighTemperatureShutoffwithDelay
Zephyr 2
120
Volts/15
Amps/60Hz
HighTemperature Shutoff with Delay
Zephyr2
Helios 4
240 Volt
120Volts/15Amps/60Hz
High Temperature Shutoff with Delay
Zephyr2
B
B
C
sunlightsupply.com
120Volts/15Amps/60Hz
High Temperature Shutoff with Delay
Zephyr2
A
120Volts/15Amps/60Hz
High Temperature Shutoff with Delay
Zephyr2
B
C
120Volts/15Amps/60Hz
High Temperature Shutoff with Delay
Zephyr2
A
/