Greenlee 758 Ratchet Cutter Blade User manual

Type
User manual
SERVICE BULLETIN
50035487
Blade Replacement Kit
for 758 Heavy-duty Ratchet
Guy Wire Cutter
99943581 © 2019 Greenlee Tools, Inc. SB 289 REV 2 3/19
Read and understand all of the instructions and
safety information in this manual before operating
or servicing this tool.
Register this product at www.greenlee.com
50035487 Blade Replacement Kit
Replacing the Blades
To release tension on chain drive:
1. Clamp the handle assembly in a vise so that the
handles are horizontal.
2. Spread the handles apart to extend the chain drive.
3. Place a screwdriver or other device through the
chain about three links away from the handle. This
removes tension on the chain and makes it easier to
change blades. Make sure the screwdriver will not
slip out during the blade changing procedure.
To remove and replace cutting blade:
1. Remove the pivot bolt, washers, and nut.
2. Remove the cutting blade shoulder bolts, washers,
and nuts.
3. Slide the old cutting blade from between the holder
blades.
4. Slide in the new cutting blade.
5. Reinstall the hardware. The pivot bolt should be
snug but turn freely in the assembly.
To remove and replace insert blade and blade holders:
1. Remove the pivot bolt, washers, and nut.
2. Remove the insert blade shoulder bolts, washers,
and nuts.
3. Slide the old insert blade from between the holder
blades.
4. Remove and replace blade holders by removing bolts.
5. Slide in the new insert blade.
6. Reinstall the hardware.
Introduction
This service bulletin describes how to replace the
blades on the Greenlee 758 Guy Wire Cable Cutter.
It should be used in conjunction with the instruction
manual for this cutter.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from ying
debris.
The cutting blade and insert blade are a matched set.
Replace both blades at the same time.
KEEP THIS MANUAL
Handle Assembly
Pivot Bolt
Cutting Blade
Shoulder
Bolts
Cutting Blade
Insert Blade
Insert Blade
Shoulder
Bolts
Blade Holder Bolts
Blade Holder
For more detailed parts information,
refer to the instruction manual for
this tool: 99921715 (IM 1267).
4455 Boeing Drive • Rockford, IL 61109-2988 • USA • 815-397-7070
©2019 Greenlee Tools, Inc. • An ISO 9001 Company
USA Tel: 800-435-0786
Fax: 800-451-2632
Canada Tel: 800-435-0786
Fax: 800-524-2853
International Tel: +1-815-397-7070
Fax: +1-815-397-9247
www.greenlee.com
  • Page 1 1
  • Page 2 2

Greenlee 758 Ratchet Cutter Blade User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI