Livex Lighting 73951-07 Installation guide

Type
Installation guide

Livex Lighting 73951-07 is a ceiling mount fixture that provides ample lighting for your indoor spaces. It features a sleek and modern design that complements a variety of décor styles. The fixture is easy to install and accommodates multiple light bulbs, allowing you to customize the brightness to your liking. Its durable construction ensures long-lasting performance, making it a reliable choice for your lighting needs.

Livex Lighting 73951-07 is a ceiling mount fixture that provides ample lighting for your indoor spaces. It features a sleek and modern design that complements a variety of décor styles. The fixture is easy to install and accommodates multiple light bulbs, allowing you to customize the brightness to your liking. Its durable construction ensures long-lasting performance, making it a reliable choice for your lighting needs.

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT#73951 73952
For Ceiling Mount Fixtures
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
1. Shut off the power at the fuse box or circuit breaker box.
Remove the old fixture from ceiling, including the single
bar.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread the two mounting screws about 1/4”into the
pre-drilled holes in the single bar spaced the same distance
apart as the holes in the pan (A).
4. Attach the single bar to the Junction Box using the two
screws from the Junction Box. The side of the single bar
marked "GND" must face out.
5. Hold the pan (A) towards the single bar and connect the
electrical wires as follows (See Fig.2). Connect the black
wire from the fixture to the black house (hot) wire; connect
the white wire from the fixture to the white house (neutral)
wire. Make sure all wire nuts are secured. You may wrap
the connections with electrical tape. If your Junction box
has a ground wire (green or bare copper) connects fixture’s
ground wire to it. Otherwise attach the bare copper fixture
wire to the green ground screw on the single bar. Tuck the
wire connections neatly into the ceiling junction box as you
are holding the fixture assembly toward the ceiling.
6. Finish mounting the pan (A) by placing it over both
mounting screws so that the screws protrude from the
keyholes in the bottom of the pan (A). Rotate the pan (A)
until the screw are seat in the slots of the keyholes and
tighten it with a screwdriver.
7. Install the light bulbs in accordance with the fixture’s
specifications.
DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
8. Attach the glass shade(B) to the big ring(D), raise the
assembly to the pan , aligning the thread hole of pan with
the ring's hole, then tighten it with the screws(C).
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
A
B
D
C
screw
Fig.2
MIN 90℃ SUPPLY CONDUCTORS
DOC20150973951
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
  • Page 1 1

Livex Lighting 73951-07 Installation guide

Type
Installation guide

Livex Lighting 73951-07 is a ceiling mount fixture that provides ample lighting for your indoor spaces. It features a sleek and modern design that complements a variety of décor styles. The fixture is easy to install and accommodates multiple light bulbs, allowing you to customize the brightness to your liking. Its durable construction ensures long-lasting performance, making it a reliable choice for your lighting needs.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI