1. Choose location to install Screen Door Opener:
a. From outside, close screen door and slide.
b. Mark location to drill on exterior side of slide.
c. When slide is closed completely, hole should be
centered directly above screen door handle
(see figure 1).
d. Hole must be drilled on flat area (do not mark or drill
through bend or angle in slide (see figure 1).
e. Carefully drill hole with 9/16” bit
(recommend drilling smaller pilot hole first).
2. Gently ease endcap and grommet off latch.
3. From interior side of screen door, insert grommet into
drilled hole with grommet hole angled downward
(see figure 2).
4. Slide latch through hole and reattach endcap
(see figure 3).
5. Adjust latch until it moves up and down freely when
exterior RV door is closed (see figure 4). If desired,
add 1 drop super glue between latch and grommet to
permanently fix location.
Installation Instructions:
Tools Needed
Parts
Latch
Grommet
Endcap
Will not work with
Airstream™ doors*
Assembled
*Airstream is a trademark
of Airstream Inc.
Drill and 9/16” bit
Exterior
Side
View
Interior
Exterior
DON’T
DRILL
HERE
DRILL HERE
Our return policy is limited to the replacement of original purchase. No
other liability, responsibility or warranty is expressed or implied,
including any regarding merchantability or suitability for a particular
purpose. Our return policy is limited to the replacement of original
purchase. No other liability, responsibility or warranty is expressed
or implied, including any regarding merchantability or suitability for a
particular purpose.
RV
Screen Door Opener
Makes getting out easier!
Open your screen door • Keep your slide closed • Leave bugs outside
Camco Manufacturing Inc.
121 Landmark Dr. / Greensboro, NC 27409
1-800-334-2004 / www.camco.net
z885066
/
