Sunricher SRP-2305-48-75LCV User manual

Sunricher
Brand
Sunricher
Model
SRP-2305-48-75LCV
Type
User manual

Sunricher SRP-2305-48-75LCV is a powerful and versatile LED driver that offers a wide range of features and capabilities. With its high output power of 75W, it can easily drive even the most demanding LED fixtures and lighting systems. The SRP-2305-48-75LCV is also highly efficient, with a typical efficiency of 89% at 230VAC full load. This means that it will waste less energy and save you money on your electricity bills.

One of the most notable features of the SRP-2305-48-75LCV is its built-in DALI interface.

Sunricher SRP-2305-48-75LCV is a powerful and versatile LED driver that offers a wide range of features and capabilities. With its high output power of 75W, it can easily drive even the most demanding LED fixtures and lighting systems. The SRP-2305-48-75LCV is also highly efficient, with a typical efficiency of 89% at 230VAC full load. This means that it will waste less energy and save you money on your electricity bills.

One of the most notable features of the SRP-2305-48-75LCV is its built-in DALI interface.

Function introduction
Important: Read All Instructions Prior to Installation
75W 48V DALI DT6 Dimmable LED Driver
Product Data
MTBF
Dimension
Warranty 5 Years
Others
Over Voltage Yes, recovers automatically after fault condition is removed
Over Load
Short Circuit
Over temperature
Protection
Yes, recovers automatically after fault condition is removed
Yes, recovers automatically after fault condition is removed
Yes, recovers automatically after temperature drop
Max. Case Temp. 85℃ (Ta="50℃")
Working Humidity
Working Temp.
Environment
-25℃ ~ +45℃
10% ~ 95% RH non-condensing
Storage Temp.
& Humidity -40℃ ~ +80℃, 10% ~ 95% RH
Withstand Voltage I/P-O/P: 3.75KVAC
Isolation Resistance
Safety Standards
Safety &
EMC
IEC/EN61347-1, IEC/EN61347-2-13
I/P-O/P: 100M Ohms / 500VDC / 25℃ / 70% RH
EMC Emission EN55015, EN61000-3-2 Class C, EN61000-3-3
EMC Immunity EN61000-4-2,3,4,5,6,8,11, EN614547
306.6*43*30mm (L*W*H)
Voltage Range 220-240V AC
Power Factor (Typ.)
Efficiency (Typ.)
Frequency Range 50/60Hz
Input
Rated Power Max. 75W
Output
Max. Current
DC Voltage 48V DC
Max. 1.56A
LED Channel 1 Channel
Voltage Tolerance ±3%
> 0.95 @ 230VAC
Total Harmonic
Distortion
Standby Power
Consumption
AC Current (Typ.)
89% @ 230VAC full load
THD ≤ 14% (@ full load / 230VAC)
0.37A @ 230VAC
Leakage Current < 0.5mA /230VAC
< 0.5W
L-N:2KV
Anti Surge
Control
Dimming Interface
Dimming Range
Dimming Method
0.1%-100%
DALI DT6 (DALI consumption<2mA) / Push
Pulse Width Modulation
Dimming Curve Linear/Logarithmic optional
• DO NOT expose the device to moisture.
• DO NOT install with power applied to the device.
Safety & Warnings
• Dimmable LED driver, max. output power 75W total
• 1 channel DC 48V constant voltage output
• High power factor and efficiency
• PWM dimming,smooth and deep dimming to 0.1%
• Compatible with universal DALI masters that support DT6 commands
• Error report function
• IP20 rating, suitable for indoor LED lighting applications
• Built-in DALI-2 interface, DALI DT6 device
• In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2
• Built-in DALI interface, DALI DT6 device, each device is controlled via a single DALI address
• 5 years warranty
Operation
Inrush Current (Typ.) COLD START Max. 35A @ 230VAC
191500H, MIL-HDBK-217F @ 230VAC full load and 25°C
ambient temperature
AC 220-240V input
DALI/Pu sh sign al input
1. DALI Address
1 DALI address for 1 channel output are assigned by DALI Master controller automatically, please refer to user
manuals of compatible DALI Masters for specific operations.
2. PUSH Dimmer Mode
While connected with a AC PUSH, the driver will be in Push Dimmer Mode, operations under Push Dimmer Mode
are as follows:
2.1. Click the button to switch ON/OFF
2.2. Press and hold down the button to increase or decrease light intensity to desired level and release it, then
repeat the operation to adjust light intensity to opposite direction. The dimming range is from 0.1% to 100%.
2.3. Memory function after power off or power failure enables the device to memorize the status before power off
while power on again.
2
N
L
INP UT
220 -240 VAC
75W DALI DT6 LED Driver
LED OUTP UT
-
NC
DA
DA
DAL I
SIG NAL
PUSH D IM
L
N
DA
DA
NC
NC
NC
Wiring diagram
DALI signal
DALI
Maste r
Product Dimension
1. With DALI Bus
AC Power
50/60Hz
266.6 mm
306.6 mm
43 mm
43 mm
30 mm
N
L
INP UT
220 -240VA C
75W DALI DT6 LED Driver
LED O UTPUT
-
NC
DA
DA
DAL I
SIG NAL
PUSH D IM
L
N
DA
DA
NC
NC
2. With Push Dim
N
L
INP UT
220 -240VA C
75W DALI DT6 LED Driver
LED O UTPUT
-
NC
DA
DA
DAL I
SIG NAL
PUSH D IM
L
N
DA
DA
NC
NC
L N
PUSH
NC
Conne ct with LED st rip
Conne ct with LED st rip
NC
  • Page 1 1
  • Page 2 2

Sunricher SRP-2305-48-75LCV User manual

Sunricher
Brand
Sunricher
Model
SRP-2305-48-75LCV
Type
User manual

Sunricher SRP-2305-48-75LCV is a powerful and versatile LED driver that offers a wide range of features and capabilities. With its high output power of 75W, it can easily drive even the most demanding LED fixtures and lighting systems. The SRP-2305-48-75LCV is also highly efficient, with a typical efficiency of 89% at 230VAC full load. This means that it will waste less energy and save you money on your electricity bills.

One of the most notable features of the SRP-2305-48-75LCV is its built-in DALI interface.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents